GaleMed AR0058 Руководство по эксплуатации - Страница 3

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Респираторный продукт GaleMed AR0058. GaleMed AR0058 11 страниц.

Principles Of Operation 1

™

The MR‐100

Plus Manual Resuscitator consists of four major components

(figure 1): non rebreathing valve assembly (A), silicone bag (B), intake valve

(C), and reservoir (D), Part D should be removed if supplemental oxygen is

not to be supplied from an external gas source.

Figure 1. The MR100

Plus Manual Resuscitator

Gas is delivered to the patient by squeezing the bag (see figure 2). Positive

pressure within the bag caused by its compression closes the intake valve (E)

located at the base of the bag. This causes the duckbill valve (F) to close off

the expiration ports(G) of the non‐rebreathing assembly. Further

compression of the bag forces gas through duckbill valve to the patient. If

supplemental gas is used, oxygen is delivered to the reservoir (D) during

compression of the silicone bag.

Figure 2. Exhalation

Principles Of Operation 2

Exhalation begins when the patient exerts positive pressure (during passive

exhalation) on the patient side of the duckbill valve (F) or when the operator

releases pressure from the silicone bag (8). The valve lifts directing the

patient's expiratory gases through the expiration ports(G) of the non‐

rebreathing valve (see figure 3).

Figure 3. lnspiration

The silicone bag refills for the next breath during patient exhalation.

Negative pressure within the bag (caused by the expansion of the

compressed bag) opens the intake valve (E), allowing gas to enter the bag

either from the atmosphere or from the reservoir (D).

The reservoir should be used whenever supplemental oxygen Is delivered.

(Supplemental oxygen may be administered without using the reservoir but

maximum available oxygen concentration will be reduced.) Excess oxygen

vents to the atmosphere through the safety valve

(H) should the reservoir fill before the next delivered breath. If the volume of

gas in the reservoir is inadequate to fill the silicone bag, room air may be

drawn in through the reservoir valve safety inlet (I). The concentration of the

oxygen‐enriched gas entering from the reservoir will depend on factors such

as oxygen now rate, tidal volume, ventilation rate and operator technique.