DynaStar Grappler Руководство - Страница 5

Просмотреть онлайн или скачать pdf Руководство для Игрушка DynaStar Grappler. DynaStar Grappler 8 страниц. Mid-power model rockets

19. Apply a bead of wood glue to both

sides of each ﬁn-body tube joint. Pull your ﬁn-

ger along the joint to smooth out and remove

the excess glue. Lay the tube horizontally

while the glue dries.

20. Using wood glue, attach the launch

lug to the tube on the pencil line; position it

so that it is ﬂush with the seam where the two

body tubes meet. Allow the glue to dry. Apply

a bead of wood glue to both sides of each

launch-body tube joint. Pull your ﬁnger along

the joint to smooth out and remove the excess

glue. Lay the tube horizontally while the glue

dries.

21. After all the glue has completely dried,

you may now paint your Grappler model

rocket (Note: you can temporarily put the nose

cone on the white body tube while you paint

the rocket).

Roll a piece of paper and insert it into the

aft end of the body tube so you can hold the

model while painting it. For best results, paint

the model with primer before using the ﬁnal

paint colors. Follow the directions on the paint

can, and always paint outdoors with the wind

against your back. Let the paint harden at

least 24 hours before proceeding.

22. Cut around the perimeter of the de-

cal with a pair of scissors. Peel off the paper

backing, and afﬁx the decal in place on the

model. Use the picture on page 1 for decal

placement.

23. Tie the loose end of the shock cord to

the loop on the base of the nose cone using 2

overhand knots. Apply a little bit of the wood

glue onto the knot to keep it from coming

untied.

Front edge of launch lug even with tube seam.

Nose Cone: paint "silver"

Fins: paint "silver"

Body Tube: paint "black"

Page