AUTOPILOT SYSTEMS Pool Pilot Digital Руководство пользователя - Страница 13

Просмотреть онлайн или скачать pdf Руководство пользователя для Осветительное оборудование AUTOPILOT SYSTEMS Pool Pilot Digital. AUTOPILOT SYSTEMS Pool Pilot Digital 16 страниц. Swimming pool and spa purification system

Печатать страницу

Section 4a –SERVICE and MAINTENANCE

CONTROL BOX AND FUSE LOCATIONS

There are little serviceable parts on the Pool Pilot™ Digital Control Box except the fuses. For any other problems with the

Control Box, please contact the Factory or Authorized Dealer/Service Center.

To remove the Control Box Cover and access the fuses, follow these steps.

DANGER: TURN OFF THE POWER FROM THE CIRCUIT BREAKER BEFORE SERVICING THIS UNIT.

POOL PILOT™

Digital

Front of Unit

Top Cover

Loosen (4) knobs

(you do not need to)

(remove these).

Fuse Location and Ratings

The Tri-sensor assembly tests for Flow, Salt, and Water temperature. A minimum flow rate of 15 gpm (3.4 m³/hr) is required

to activate the flow switch. As the water flow closes the paddle, a magnet activates a micro switch to verify proper flow. The

Salt sensor protects against low salt levels, and the temperature sensor protects against cold water temperature operation and

over chlorination when cold. Both of which can contribute to accelerated cell failure.

Note: The use of high strength magnet devices in the close proximity of the tri-sensor can cause the flow switch to read

incorrectly.

Remove the Tri-Sensor as follows (with pump off):

Remove both screws from the sides of the Tee Assembly.

With the aid of large Channel-lok® (or similar) pliers, firmly

grip the Tri-Sensor assembly and move back and forth

while removing the Tri-Sensor from the tee.

Inspect the thin metalic paddle for erosion and straightness.

Take care not to twist or tweak this paddle, which can cause

inaccurate flow readings.

Inspect the salt sensor blades for scale and debris and clean

if necessary. See page 13 for cleaning instructions. Follow

the directions for Manual Cell Cleaning.

Check the tri-sensor assembly for any damage to the plastic

housing and replace if needed.

Control Circuit Board

Wire Harness Connection

Inside Top Cover

Lift off cover and disconnect

wire harnesses (Control Circuit

board removes with cover).

Main AC Power Fuse

Control Panel Circuit Board Fuse

Cell Fuse

TRI-SENSOR ASSEMBLY

Inner Metal

Cover

Remove (4) screws and

lift off metal cover.

The (4) Mounting holes,

each corner are accessed here

(without removing metal cover).

3 Amps 250 VAC (6 Amps @ 115 VAC)

3 Amps 250 VAC

20 Amps 250 VAC

screws

one on each side

Access is gained to

electrical connections,

fuses, and pump/aux

relay.

directional

arrow