AUTOPILOT SYSTEMS Pool Pilot Digital Руководство пользователя - Страница 5

Просмотреть онлайн или скачать pdf Руководство пользователя для Осветительное оборудование AUTOPILOT SYSTEMS Pool Pilot Digital. AUTOPILOT SYSTEMS Pool Pilot Digital 16 страниц. Swimming pool and spa purification system

Печатать страницу
Section 2a – INSTALLATION
CHECK
SYSTEM
BOOST
MENU
SELECT
PUMP
Control Box
converts incoming AC power to a Low
Voltage DC current, which energizes the
Cell(s).
SPECIFICATION RATINGS:
Input Power:
115 VAC (3.0 AC amps)
230 VAC (1.5 AC amps)
50/60 Hz
Output Power: Cell Power 1 (5.0* DC amps)
Cell Power 2 (6.5* DC amps)
Cell Power 3 (8.0* DC amps)
*Indicates nominal amperage output. The dual axis controller will slightly vary the amps to optimize the power to the cell.
12' (3.6 m) of Cell and Tri-Sensor cords are provided with the unit. Ensure that the manifold is located within that distance
from the control box with enough slack to allow for removal for service or maintenance.
The Digital display provides full information and diagnostics for maintenance and operation of your system. The
programmable settings are retained on a microprocessor chip with the clock setting backed-up with a CR-2025 lithium battery.
CAUTION: To avoid over-saturation conditions of your spa, it is suggested to locate the cell downstream of all other
equipment and on the pool return line only. For applications other than as recommended, contact the factory.

CONTROL BOX INSTALLATION

DRILL ¼" (6mm)
DRILL ¼" (6mm)
TOP
TEMPLATE FOR DRILLING
POOL PILOT SOFT TOUCH
& POOL PILOT DIGITAL
MOUNTING HOLES.
DRILL 4 ¼" (6mm) HOLES FOR
WALL ANCHORS WHERE SHOWN.
P/N 18550
BOTTOM
DRILL ¼" (6mm)
DRILL ¼" (6mm)
Place Template on
mounting location. Level,
mark holes and drill.
insert into drilled holes.

Main Components

Flow In
Patented Automatic Flow Bypass Manifold Assembly
ELECTROLYTIC SUPERCELL
receives Low Voltage DC current from
the Power Circuit Board, which initiates
the electrolytic process.
Use the (4) provided
Attach the (4)
plastic anchors and
provided screws,
leaving a ¼" gap.
Tri-Sensor Assembly
Super Cell
Maximum daily
Cl
Output Rating:
2
@ Cell Power 3
(8 amps DC)
Agency Approvals: NSF, ETL
Internal Pump Relay is rated for 30-amp max.
POOL PILOT
DIGITAL
Loosen four
fastening screws
and lift off cover.
4
Maximum Operating Pressure: 50 psi
Maximum Flow Rate: 100 gpm
Flow Out
TRI-SENSOR ASSEMBLY
ensures that adequate Flow,
Salt Level, and Water
Temperatures are satisfactory to
prevent abusive conditions for the
cell to operate.
SC-60
1.92 lbs/day (0.88 kg/day)
SC-48
1.56 lbs/day (0.71 kg/day)
SC-36
1.28 lbs/day (0.58 kg/day)
, ETL
, CE
US
C
Mount the Control
Disconnect (4)
the (4) mounting
wire harness.
Box and tighten
screws.