High-End Technology F16 Инструкция по сборке - Страница 4
Просмотреть онлайн или скачать pdf Инструкция по сборке для Игрушка High-End Technology F16. High-End Technology F16 18 страниц. High-end technology f16 for electric ducted fan
Печатать страницуAssemble the servo-brackets, there's a high-side and a low side on the bracket, so
the sides are different. The small edge on the Servo tray should be on top. The
bottoms of the sides are almost square.
Next to the servo bracket on the right side picture you see the pivot-block and servo
bracket, they are in the approximately location. First glue the Pivot-blocks on both
sides inside the fuselage with 5 minute epoxy.
Mark the position for the Pivot-rod ( 2 3 mm steel rods one for each side) 62 mm
from the end of the fuselage . Drill a little oversized hole in the middle at the marked
location. We recommend a 4 mm hole. Wait before you glue the pivot rod in place.
Put some tape on the fuselage side as in the picture and mark the location for the
servo "hatch" size is approximately 35 X 12 mm. the opening should be big enough to
let your servo go through. Before you cut the opening be sure that the servo bracket
will fit behind. Now cut the opening with a cutting wheel on your dremel or use a
sharp knife.