Dynasty Fireplaces EF44D Инструкция по установке и руководство по эксплуатации для владельца дома - Страница 6
Просмотреть онлайн или скачать pdf Инструкция по установке и руководство по эксплуатации для владельца дома для Электрический нагреватель Dynasty Fireplaces EF44D. Dynasty Fireplaces EF44D 8 страниц. Electric heater with remote control
Также для Dynasty Fireplaces EF44D: Инструкции по установке и руководство по эксплуатации (9 страниц)
Печатать страницу
ELECTRICAL CONNECTION
A 15 AMP, 120 Volt, The unit comes standard with 6 feet (1.8 m) three wire cord and plug, exiting
from the rear of the fireplace. Plan the installation to avoid the use of an extension cord. Preferably,
the fireplace will be on a dedicated circuit as other appliances on the same circuit may cause the
circuit breaker to trip or the fuse to blow when the heater is in operation.
OPERATING INSTRUCTION
This appliance can be operated by both remote control and manual button. Once the unit has been
properly connected to a grounded electrical outlet, turn on the main power switch located on the left
hand side of the appliance. A beep should be heard when the power is first applied.
CAUTION! The unit's power cord must be connected to a properly grounded and
protected 120V outlet. Always use ground fault protection where required by the
electrical code.
WARNING! Do not operate the unit if it is damaged or has malfunctioned. If you suspect
the unit is damaged, please call a qualified service technician to inspect and to replace
any part of the electrical system if necessary.
NOTE! To use both remote and manual function, the main power switch must be in "ON" position.
● Operating by Manual Button
NOTE! The manual button on the fireplace unit does not provide you with all function control, and
its purpose is to control some basic functions if you lose the remote handset. Please use the
remote handset to carry out all functions.
NOTE：The lights will always be lit when the appliance is on.
Main power switch
The POWER switch supplies power to all of the functions of the fireplace. This switch must be in
the "ON" position for any of the functions including the remote to work.
Flame button
By pressing the FLAME button, the unit will cycle through five flame effects. If you need more flame,
please use the remote handset.
Heater button
Press the HEATER button once to turn to LOW setting. (Pilot lights illuminated ●○).
Pressing again turns the heater to HIGH Setting. (Pilot lights illuminated ●●)
Pressing a third time turns the heater OFF. (Pilot lights illuminated ○○).
There are 3 levels you can cycle through including the OFF setting.
6