Autoplugin RCP-V5 Руководство пользователя - Страница 4
Просмотреть онлайн или скачать pdf Руководство пользователя для Модули GSM/GPRS Autoplugin RCP-V5. Autoplugin RCP-V5 12 страниц.
Печатать страницуIf entered digit is not correct, enter the code once more in that case. Several codes
can be entered without exit of setup mode.
Turn the ignition off to exit setup mode. New settings are saved in nonvolatile
memory of the module and stored there regardless of whether the module is
connected or not to the car. Note: If you start the engine during Setup mode, new
settings will not be saved in memory.
To reset the module to the factory settings, enter the code 8.1.1. The LED should
flash three times, confirming command execution. Then the module exits Setup
mode and restarts.
Settings
Settings
Group
Item
1.
1.1. Limitation of
Heater
heater total
operation
operational time in
time
pre-heat mode
1.2. Limitation of
heater 1-cycle
operational time in
pre-heat mode
2.1. "Lock" and
"Unlock" buttons
functions for heater
control
2.2. Number of
sequential "Unlock"
button presses for
heater control
2.3. Number of
sequential "Lock"
button presses for
heater control
3.
3.1.
Battery
Minimal battery
4
Possible Values
1.1.1 *Not adjusted
1.1.2 40 minutes
1.1.3 50 minutes
1.1.4 60 minutes
1.1.5 70 minutes
1.1.6 80 minutes
1.1.7 90 minutes
1.1.8 100 minutes
1.1.9 120 minutes
1.2.1 10 minutes
1.2.2 15 minutes
1.2.3 20 minutes
1.2.4 25 minutes
1.2.5 30 minutes
1.2.6 40 minutes
1.2.7 50 minutes
1.2.8 *Not used
2.1.1 *"Lock" button for heater start,
"Unlock" button for heater stop
2.1.2 "Unlock" button for heater start,
"Lock" button for heater stop
2.2.1 Combination disabled
2.2.2 * Two presses
2.2.3 Three presses
2.2.4 Four presses
2.3.1 Combination disabled
2.3.2 *Two presses
2.3.3 Three presses
2.3.4 Four presses
3.1.1 * Not adjusted
3.1.2 11.7V
Settings Table (3)