Emerson Amphora F2200TG02 Руководство пользователя - Страница 6
Просмотреть онлайн или скачать pdf Руководство пользователя для Вентилятор Emerson Amphora F2200TG02. Emerson Amphora F2200TG02 12 страниц. Derby & amphora series
Печатать страницу
1. Securely attach the hanger bracket to the outlet
box using the two screws supplied with the outlet
box. (Figure 2).
WARNING
!
Hanger bracket must seat firmly against outlet box. If
the outlet box is recessed, remove wall board until
bracket contacts box. If bracket and/or outlet box are
not securely attached, the fan could wobble or fall.
TWO SCREWS
SUPPLIED WITH
OUTLET BOX
Figure 2
2. Carefully lift the fan and seat the hanger ball/
downrod assembly on the hanger bracket that was
just attached to the outlet box (Figure 3). Be sure
the groove in the ball is lined up with tab on the
hanger bracket (Figure 2).
WARNING
!
Failure to seat tab in groove could cause damage to
electrical wires and possible shock or fire hazard.
NOTE: CEILING COVER,
SUPPLY WIRES AND
FAN WIRES OMITTED
FOR CLARITY.
Figure 3
WARNING
!
To avoid possible fire or shock, do not pinch wires
between the hanger ball/downrod assembly and
hanger bracket.
OUTLET
BOX
HANGER
BRACKET
TAB
OUTLET
BOX
HANGER
BRACKET
HANGER BALL/
DOWNROD ASSEMBLY
6
How to Wire Your
Ceiling Fan
If you feel that you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
WARNING
!
To avoid possible fire or shock, be sure that
electricity is turned off at the main fuse box before
wiring.
NOTE: If you are not sure if the outlet box is
grounded, contact a licensed electrician for advice,
as it must be grounded for safe operation.
1. Connect the green grounding lead from the hanger
ball and the green grounding lead from the hanger
bracket to the grounding conductor of supply (this
may be a bare wire or wire with green colored insu-
lation). Securely connect wires with wire connector
supplied.
BLACK AND BLUE
FAN WIRES
GROUND
WIRE
LISTED
WIRE
CONNECTOR (3)
GREEN WIRE
(GROUND) FROM
HANGER BRACKET
GREEN WIRE
(GROUND) FROM
HANGER BALL
Figure 4
NOTE: If you are using an Emerson Light Fixture
with your fan, see Light Fixture Owner's Manual
for wiring.
2. Securely connect the fan motor white wire to the
supply white (neutral) wire using wire connector
supplied (Figure 4). Securely connect the fan motor
black wire and blue wire to the supply black (hot)
wire using wire connector supplied (Figure 4). After
connections have been made, turn leads upward
and carefully push leads into the outlet box, with
the white and green leads on one side of the outlet
box and the black and blue leads on the other side
of the outlet box.
WARNING
!
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until blades are in place. Noise and fan
damage could result.
WHITE SUPPLY
(NEUTRAL)
WHITE FAN
WIRE
BLACK SUPPLY
(HOT)
NOTE: CEILING COVER
OMITTED FOR CLARITY.