Gallagher T11 PIV Reader-Multi Tech Black Примечание по установке - Страница 4
Просмотреть онлайн или скачать pdf Примечание по установке для Устройство для чтения карт Gallagher T11 PIV Reader-Multi Tech Black. Gallagher T11 PIV Reader-Multi Tech Black 13 страниц.
Печатать страницу
1
Introduction
The Gallagher T11 Reader is a mobile credential and smart card proximity reader. It can be installed as
either an entry reader or exit reader. It can be mounted on a vertical, rectangular 50 mm x 75 mm (2" x
3") flush box with mounting holes spaced at a nominal 85 mm (3.25").
The reader sends information to the Gallagher Controller and acts upon information sent from the
Gallagher Controller. The reader itself does not make any access decisions.
The reader is available in eight variants. The card technologies for each variant are shown below.
Reader
T11 Mifare Reader Black
T11 Mifare Reader White
T11 Multi Tech Reader Black
T11 Multi Tech Reader White
T11 PIV Reader Black
T11 PIV Reader White
T11 PIV Reader - Multi Tech Black
T11 PIV Reader - Multi Tech White
The reader can be connected as an HBUS Reader or Cardax IV Reader. An HBUS Reader uses the HBUS
communications protocol to communicate with the Gallagher Controller. A Cardax IV Reader uses the
Cardax IV Reader communications protocol to communicate with the Gallagher Controller.
IMPORTANT: HBUS compatibility
HBUS communications are supported with sites running Gallagher Command Centre vEL7.00 software
(or later).
IMPORTANT: Multi Tech readers
Using dual technology 125/Mifare cards with Gallagher Multi Tech readers may cause both card
technologies to be read, resulting in double card badges and unusual reader feedback. Gallagher
strongly recommends against using dual technology 125/Mifare cards with Multi Tech readers for sites
running pre-Command Centre v7.00 software. From Command Centre v7.00, a site may specify which
technology a Multi Tech reader should read off a dual technology card.
IMPORTANT: PIV readers
Gallagher PIV readers connect to the Gallagher Controller 6000 High Spec PIV (C305101) only (referred
to as the Controller). Gallagher PIV readers can only be used with sites running Gallagher Command
Centre vEL7.10 software (or later). Gallagher PIV readers are connected as HBUS Readers only.
IMPORTANT: Mobile credential readers
Gallagher Multi Tech readers support Gallagher mobile credentials using Bluetooth® wireless
technology. Mobile credentials are supported with sites running Gallagher Command Centre vEL7.60
software (or later). To use mobile credentials, the Multi Tech reader must be connected as an HBUS
Reader.
3E4289 Gallagher T11 Reader | Edition 1 | August 2016
Copyright © Gallagher Group Limited
Product codes
Supported card technologies
C300410
Mifare DESFire EV1, Mifare Plus and
C300411
Mifare Classic
C300430
Mifare DESFire EV1, Mifare Plus, Mifare
C300431
Classic and 125 KHz cards
C305410
PIV, PIV-I, Mifare DESFire EV1, Mifare
C305411
Plus and Mifare Classic
C305430
PIV, PIV-I, Mifare DESFire EV1, Mifare
C305431
Plus, Mifare Classic and 125 KHz cards
Page 4