HighLine CCU2 Руководство по установке и эксплуатации - Страница 4
Просмотреть онлайн или скачать pdf Руководство по установке и эксплуатации для Блок управления HighLine CCU2. HighLine CCU2 4 страницы. Digital climate control unit
Печатать страницу
SETUP INSTRUCTIONS
The final display is only of interest should you have a conflict between
9
the temperature shown on the controller and another device in the room.
This display allows you to alter the controller to mimic the second device.
To do so press the up and down arrow to increase or decrease the value.
Press the 'M/A' button again when you are finished.
You have now returned to the normal working display.
10
OPERATING INSTRUCTIONS
To switch from 'Manual' operation to 'Auto' function simply press
1
the 'M/A' button once and the display will show the selected mode.
In 'Manual' mode simply press the Up arrow to open, or Down arrow to
2
close. When you release the button the motor stops and the window
remains in that position until altered. The rain sensor will not function
in 'Manual'.
When in 'Auto' mode you will need to input the temperature at which
3
you wish the room to be maintained. Press the up or down arrow to adjust
accordingly. When the desired temperature is displayed just wait a few
seconds and the controller will automatically accept the new value and the
display will return to 'Auto'.
Your setup is now complete. Obviously if you wish to change anything
4
just go through the procedure above again.
In 'Auto' mode your controller will try to maintain your chosen room
5
temperature by opening/closing the actuator. It does this by only opening
the actuator 1/4 of its opening stroke at a time and depicts the actuator
position on the display. Several minutes will elapse between each opening
of the actuator so as to give the temperature time to stabilise also putting
less strain on the actuator itself as it does so.
CCU2 - USER MANUAL
(version 2014)
4