Dynaudio Xeo 10 Руководство пользователя - Страница 8
Просмотреть онлайн или скачать pdf Руководство пользователя для Динамики Dynaudio Xeo 10. Dynaudio Xeo 10 18 страниц.
Печатать страницу
Dynaudio Xeo 10/20/30
Buttons on top of the cabinet (Xeo 10)
Speaker on/off
► Press
► Press and hold
Input selection
► When switched on, press
Volume control
► Press
Remote control
Commands will always apply to both of the speakers.
MUTE
Muting the speakers
MUTE
ON
OFF
► Press
1
Line
2
Opt
3
Coax
VOLUME
Line
4
USB
A
Opt
ON/OFF
Speaker on/off
Aux
B
C
► Press
DIRECT
HUB
► Press
► Press and hold
► Press and hold
VOLUME
Volume control
► Press
INPUT
Signal source
► Press a button to select the
►
Controls
Press to control most Bluetooth 4.1
compliant devices:
14
to switch on the speakers. The Xeo 10 will scan the inputs for a
signal.
to switch off the speakers.
to jump to another input.
Bluetooth pairing
or
to raise or lower the
► Press and hold both
and
volume level. Press and hold for
start pairing (see page 16).
faster adjustment.
Fixing the volume
► Press
to mute or unmute the
for at least 2 seconds to set
speakers.
a high volume for the speakers (see
page 18).
Reset
to switch on the speakers.
► Press
for at least 5 seconds to
for standby mode.
reset the speakers to the factory
until LED turns
settings.
red, to put speaker in sleep mode.
for 5-9 seconds
to enter night mode (Turns the LED's
off).
or
to raise or lower the volume level.
Bluetooth pairing
► Press
for at least 5 seconds to
respective signal source.
enter pairing mode.
selects a Bluetooth device or
Hub/Connect.
= backward,
= play or pause,
= forward
Connecting
and setting
up
to
Connections and control elements / Connecting and setting up
Positioning and connecting to mains voltage
► Position the speaker in the desired location.
– Do not expose the speaker to direct sunlight, heat, or moisture.
– Do not place the speaker near devices with strong electromagnetic radiation or
devices that could be destroyed or damaged by magnetic fields.
► Use the power cable to connect the speaker to the mains voltage.
Tip Xeo 10:
• For easier access, the plate at the bottom of the cabinet can be removed. Use a coin
or screwdriver to loosen the screw and attach the plate after connecting the power
cable.
Cloth cover
The cloth cover has been designed so it does not influence the sound dispersion of the
speaker. It is attached to the housing with magnets and may be removed if needed.
General settings
► In stereo mode:
– Select Left operating mode for the left speaker.
– Select Right operating mode for the right speaker.
► Set the speaker position switch that best describes the speakers´ need for acoustic
compensation.
– Neutral = with free-standing placement
– Wall = if placed near a wall
– Corner = if placed in a corner
► Select the Red, Green, or Blue zone. Select the same zone for the right and left
speakers (for additional information about the audio zones, see page 26).
15