Dynaudio Xeo 30 Руководство пользователя - Страница 9
Просмотреть онлайн или скачать pdf Руководство пользователя для Динамики Dynaudio Xeo 30. Dynaudio Xeo 30 18 страниц.
Печатать страницу
Dynaudio Xeo 10/20/30
Connecting sources directly
► Connect your source cables to one or more of the audio inputs
master speaker (see „Connection options" on page 13).
After it is turned on, the speaker automatically searches for an audio signal and then
plays it back immediately. If several signal sources are active, one of the signal sources
will be played back.
Tip (Xeo 10):
• For easier access, the plate at the bottom of the cabinet can be removed. Use a coin
or screwdriver to loosen the screw and attach the plate after connecting the power
cable.
Connecting a Bluetooth device
1. To begin Bluetooth pairing, press and hold both
your speakers (Xeo 10). Alternatively, hold Bluetooth
– Once available for pairing, the status indicator will blink white and it will be
available for pairing for one minute.
2. Go to settings on your device, find the Bluetooth sub-menu, and simply pair your
device with your Xeo speaker by selecting Red, Green, or Blue. The speaker will
store your pairing.
Connecting sources via Hub or Connect
Xeo Hub and Dynaudio Connect are optional components that allow you to connect
analog and digital sources and are linked with your Xeo speaker via a wireless, lossless
signal. For further information about the complete Xeo system, please see „The Xeo
system" on page 27.
16
Aux
,
Line
,
of the
Opt
and
buttons on either one of
on remote for 5 seconds.
Connecting and setting up / Operation
Operation
Switching on
To switch the speakers on from standby mode:
► Press
on top of one of the speakers (Xeo 10) or point the remote control at a
speaker and press
.
– The speakers will automatically search for an active audio signal. If found, the
signal will be output (autoplay function).
– If there is no input signal, the speakers will continue scanning the inputs for the
next 20 minutes and enter sleep mode.
If there is no input signal, the speakers will go into standby mode after a certain period.
Playback of connected sources
► Once you have connected your Xeo speaker with a direct input, simply choose your
desired source on the remote.
– The speakers will automatically detect the signal and start playback. Master and
slave speaker will connect wirelessly if set in the same zone.
– If no signal is applied to either input, the speakers will continue scanning the
inputs for the next 20 minutes and enter sleep mode.
Playback of a Bluetooth device
Once you have paired your device with your Xeo 10/20/30, you can connect by
choosing the Xeo 10/20/30 from your list of Bluetooth devices.
► Select Bluetooth
on the remote control and press play on your Bluetooth device.
Disconnect
► Press and hold
to disconnect a connected device or disconnect from the device
directly.
17