HighPoint SSD7505 Руководство по установке - Страница 3

Просмотреть онлайн или скачать pdf Руководство по установке для Контроллер HighPoint SSD7505. HighPoint SSD7505 12 страниц. Using nvme raid aics with the dell precision 3930 rack workstation
Также для HighPoint SSD7505: Руководство по установке (14 страниц), Руководство по установке (15 страниц), Руководство по быстрой установке (6 страниц), Руководство по быстрой установке (8 страниц), Руководство по установке (14 страниц), Руководство по установке (16 страниц), Руководство по установке (19 страниц), Использование руководства (19 страниц)

Печатать страницу
HighPoint SSD7505 Руководство по установке
SSD7505 Linux CentOS7.8 Installation Guide

1 Overview

The purpose of this document is to provide clear instructions on how to install Linux
CentOS7.8 on the SSD7505 controller.
For CentOS7.8 (kernel: 3.10.0-1127.el7.x86_64)
Mirror link:
https://mirrors.bfsu.edu.cn/centos/7.8.2003/isos/x86_64/CentOS-7-x86_64-DVD-2003.iso
MD5: ef8195f42f30a23f039eef9891d496ae

2 Installing Linux CentOS7.8 on SSD7505 controller

If you would like to install Linux CentOS7.8 onto drives attached to SSD7505 controller,
please perform the following operations:

Step 1 Prepare Your Hardware for Installation

After you attach your NVMe SSD to SSD7505 controller, you can use SSD7505 EFI
Utility to configure your NVMe SSD as RAID arrays, or just use them as single disks.
Before installation, you must remove all the NVMe SSD, which are not physically
attached to SSD7505 controller, from your system.
Note
SSD7505 only support EFI boot. If you have other SCSI adapters installed, you must
make sure the SSD7505 controller EFI will be loaded firstly. If not, try to move it to
another PCI slot. Otherwise you may be unable to boot up your system.

Step 2 Check System EFI Settings

In your system EFI SETUP menu, change Boot Sequence in such a way that the system
will first boot from EFI CDROM, and then from SSD7505 RAID. Refer to your
motherboard EFI manual to see how to set boot sequence.
If your EFI settings do not support such a boot sequence, you can first set it to boot from
EFI CDROM. After you finish installation, set SSD7505 RAID as the first boot device to
boot up the system.
1. Set UEFI setting with SuperMicro X11DPi-NT motherboard as an example:
a.
Set 'Boot mode select' to 'UEFI';
- 1 -