Dcybel Liberty Руководство по эксплуатации - Страница 3

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Наушники Dcybel Liberty. Dcybel Liberty 13 страниц. Foldable bluetooth headphones

Included with the headphones:

1 x micro USB charging cable

To prevent possible hearing damage,

do not listen at high volume levels for long periods.

When the USB cable is used as the disconnect device, the disconnect device shall remain readily

operable.

CHARGING THE HEADPHONES

Before you use the headset for the ﬁrst time, fully charge the battery for approximately 3 hours.

Charging the battery fully will help you get the longest possible playback and standby time.

NOTE: Do not attempt to pair or use the headphones while it is charging.

1. Connect the small end of the supplied micro USB cable into the charging port of the speaker.

Connect the other end of the cable into the USB port on your computer.

• The charging indicator light will illuminate red.

2. When the battery is fully charged, the red indicator light will go out.

3. After charging, remove the micro USB cable.

Battery life

The fully-charged battery will provide about 8 hours of playback time depending on genres of music

and volume.

Low battery warning: When the indicator light ﬂashes red at regular intervals, please recharge the

headphones.

PARING THE HEADPHONES TO YOUR BLUETOOTH DEVICE

1. Turn on the headphones by pressing and holding

light ﬂashes red and blue alternately .

• The headphones will enter the pairing mode.

2. To pair, go to Bluetooth settings on your Bluetooth-enabled device and connect to "Liberty".

3. When the headphones are paired, the indicator light will ﬂash blue.

NOTE:

• If the headphones loses the connection (e.g. if your device is out of range), it will reconnect

automatically to your device if your device is back in range.

• Bluetooth devices have a maximum operating range of 10 metres and the actual range will vary

depending on current conditions (obstacles, battery power, interference, etc.).

To reset the Bluetooth connection with a new device, ﬁrst disconnect the paired device by pressing

and holding

for about 2 seconds.

1 x 3.5mm audio cable

for about 2 seconds until the indicator

EN-2