HighPoint R720 Руководство по установке - Страница 3

Просмотреть онлайн или скачать pdf Руководство по установке для Карта PCI HighPoint R720. HighPoint R720 15 страниц. Pci-express 3.0 x8 controller
Также для HighPoint R720: Руководство по быстрой установке (10 страниц), Руководство по установке (15 страниц)

Linux RHEL on RR3740/3720/2840/840/3742/710/720 Installation Guide

1 Overview

The purpose of this document is to provide clear instructions on how to install Linux

RHEL on the RR Series RAID controller.

 Supported system: RHEL7.2/7.3/7.9/8.3/8.5/8.6/8.7/9.0/9.1

 Supported controller: RR3740/3720/2840/840/3742/710/720

2 Installing Linux RHEL on RR Series RAID

controller

If you would like to install Linux RHEL onto drives attached to RR Series RAID controller,

please perform the following operations:

After you attach your hard disks to RAID controller, you can use EFI Utility to configure

your hard disks as RAID arrays, or just use them as single disks.

Before installation, you must remove all the Hard disks, which are not physically attached

to RAID controller, from your system.

Note

RAID Controller support EFI boot. If you have other SCSI adapters installed, you must

make sure the RR Series controller EFI will be loaded firstly. If not, try to move it to

another PCI slot. Otherwise you may be unable to boot up your system.

In your system EFI SETUP menu, change Boot Sequence in such a way that the system

will first boot from EFI CDROM or EFI a Bootable USB drive, after you finish

installation, set RR Series RAID as the first boot device to boot up the system. Refer to

your motherboard EFI manual to see how to set boot sequence.

1. Set UEFI setting with SuperMicro X11DPi-NT motherboard as an example.

"Advanced->PCIe/PCI/PnP Configuration->CPUSlot PCI-E OPROM"

to "EFI". Suppose RAID Controller is connected to motherboard CPU1 Slot 2

PCI-E X16, then you should set "CPU1 Slot 2 PCI-E X16 OPROM" to "EFI";

- 1 -