Gallien-Krueger 2001RBP Руководство пользователя - Страница 16
Просмотреть онлайн или скачать pdf Руководство пользователя для Усилитель Gallien-Krueger 2001RBP. Gallien-Krueger 2001RBP 20 страниц. Bass amp and preamp
Также для Gallien-Krueger 2001RBP: Руководство пользователя (20 страниц)
Печатать страницу
1 0 . D i r e c t O u t :
G n d / L i f t :
This switch disconnects the ground on the balanced,
XLR output to eliminate hum and buzz when
connnecting to equipment that is running on a
different ground system.
P r e / P o s t
E Q :
Selects the direct out signal before or after the EQ.
D i r e c t L e v e l O u t :
Electronically balanced adjustable output, that you
can run to your P.A. system.
1 1 . S e n d , R e t u r n & Tuner:
S e n d :
Line level output that is post EQ and pre Boost. Used
when sending a full range mono signal to an
extrernal device (effects, processors, etc.)
R e t u r n :
Accepts line level return from external effects that are
connected in a "series loop".
T u n e r :
Output comes directly off the input stage and can be
patched to a tuner with a shielded patch cord. This
output is unaffected by the Tuning Mute feature.
1 2 . C h a i n I n & C h a i n O u t :
This "daisy chain" feature is used when multiple
2001RBs are used as "master" and "slave" units.
Both jacks are stereo, where the "tip" is the "woofer
output" and the "ring" is the "horn output".
C h a i n i n :
When the master amp's "Chain out" signal is input to
the slave amp's "Chain in", the slave amp's preamp/
tone control section is bypassed completely, and will
serve as a straight power amp only.
C h a i n o u t :
This output is used to "daisy chain" or connect other
slave amps to the master amp. The signal going into
the slave amp's "Chain in" is the same signal coming
out of the "Chain out". This eliminates the need for
special Y-adapters.
N O T E :
When using the "Daisy-Chain" feature, the stereo
cable cord should be one foot in length or as short as
possible to reduce hum/noise.
M a x i m u m
R e c o m m e n d e d
Two 4 Ohm or four 8 Ohm cabinets per side, dual
mono mode. One 4 Ohm or two 8 Ohm cabinets in
bridged mode. One or two 8 Ohm horns on the 50W
Amps.
2001RB & 2001RBP
CAUTION:
UNDER NO CIRCUMSTANCES
SHOULD THE 540W AMP AND
THE 50W AMP BE CONNECTED
TO EACH OTHER OR BE
CONNECTED TO THE SAME
SPEAKER !!!
L o a d s :
16