Gallo Tech GTS-3RS Руководство по эксплуатации и установке - Страница 8

Просмотреть онлайн или скачать pdf Руководство по эксплуатации и установке для Автомобильная сигнализация Gallo Tech GTS-3RS. Gallo Tech GTS-3RS 16 страниц. Keyless rfid push button start & security system

Печатать страницу

1. Installation Instructions

9. Auxiliary Output (Door unlock Option):

Unlock Doors (default) When the Auxiliary output is activated the central doors will also unlock.

Do Not Unlock Doors (optional) When the Auxiliary output is activated the central doors will not unlock.

NOTE: The Auxiliary Output is a low current output (125ma max.). A relay must be used to activate devices such as

door poppers, trunk release or window close modules

10. Electrical Siren/ Horn:

Electrical Siren (default): Set if the 6 tone siren (included) is used.

Horn: Set if the vehicle's horn is to be used instead of the 6 tone siren. An additional relay may be required. The

control module siren output is a low current output (125ma max.) and must go through a relay to operate a vehicle's

horn.

11. Central Locking Time: When pressing

mechanism can be set at either 0.8 seconds or 4 seconds. Most cars will function properly when this option is set to

the factory default of 0.8 seconds.

(Default): 0.8 sec pulse

(Option): 4 second pulse

12. Door Unlock Pulses: Some vehicles require 1 unlock pulse to unlock the driver's door only and a second pulse

to unlock all doors. Most vehicles only require 1 unlock pulse (Default setting) to unlock all doors.

1 Pulse (Default): 1 unlock pulse. Set to unlock drivers door only in 2 pulse vehicles then press

all doors. Also use for vehicles requiring only 1 pulse to unlock all doors.

2 Pulses (option): 2 unlock pulses. Set to unlock all doors in vehicles requiring 2 pulses. Central Locking Time

#11 must be set to default (0.8 sec) for 2 pulse operation.

13. Voltage/Tach Engine running detection

Voltage (alternator) detection (default): When starting the engine with Remote Start, The system will wait for a

few seconds to determine if the voltage has risen as a result of the engine running.

Tach Signal detection (optional) When starting the engine with Remote Start, The system will wait for a few

seconds to determine if a Tach signal has been detected as a result of the engine running. See Sec 1.4 for details.

14. Return Factory Default: Resets all Function Options to factory default settings.

1.6 Key FOB & PROGRAM FUNCTION SET UP

A. Code learning (for replacement transmitters only)

Transmitter (Key FOB) Code learning: The Key FOBs have been matched to the control module at the factory. If

replacement key FOBs are used they must first be learned to the Control Module before they will function.

1. System must be in Disarm mode (green "Start/Stop Engine" button LED flashing). Both key FOBs should be in

the vehicle.

2. Press the valet switch 3 times; on the 3

learning mode. The green "Start/Stop Engine" button LED will light solid green, and the parking lights will flash 2

times.

3. Immediately (within 5 seconds) press the

Then press the

learning is now complete.

button on the second FOB within 5 sec. The parking lights will again flash 4 times. Code

the electrical pulse sent to the door locking/unlocking

press hold the valet switch for over 5 seconds, it will enter the code

button on the first key FOB. The parking lights will flash 4 times.

- 8 -

again to unlock

061515V54RS