AGS Merlin 1000S Руководство по установке, эксплуатации и техническому обслуживанию - Страница 9

Просмотреть онлайн или скачать pdf Руководство по установке, эксплуатации и техническому обслуживанию для Контроллер AGS Merlin 1000S. AGS Merlin 1000S 10 страниц. Gas utility isolation controller
Также для AGS Merlin 1000S: Руководство по эксплуатации и установке (10 страниц), Руководство по установке и эксплуатации (12 страниц), Руководство по установке и эксплуатации (16 страниц)

Merlin 1000S

Gas Utility Controller

1) [POWER] Mains Input 110-120VAC Single Phase.

2) [GAS VALVE] Gas Solenoid Valve Power Output, 110-120VAC, Max 3A.

3) [BMS OUT] Building Management System output contacts.

Normally Closed, Common and Normally Open. Max.1A @ 110-120VAC.

4) [PRESSURE SENSOR] Gas pressure transducer, power supply and returned signal (supplied).

5) [EM REMOTE] Remote EM Stop buttons and Fire Alarm input wired in series VOLT FREE

(Purchased separately).

6) [GAS DETECTOR] Methane, CO or LPG Detector, power supply and VOLT FREE

(Purchased separately).

7) [FS1/2/3/4] Fan Switch output (purchased separately).

For wiring instruction see Fan Switch user manual.

8) [CO2 MONITOR] CO2 Monitor (purchased separately). VOLT FREE

9) [12VDC] Permanent 12VDC output when there is power at the panel. 50mA max

Panel Net Weight: 1161g

Panel Dimensions: (W) 10" x (L) 7" x (D) 2.4"

MAINS AND LOW WIRING SHOULD NOT RUN IN THE SAME CONDUIT AS PER THE LOW VOLTAGE DIRECTIVE

Rev: 05 Date: 29-10-18

1000S WIRING

PLEASE NOTE:

User & Installation Manual