AGS Parksafe Control Panel Руководство по установке и эксплуатации - Страница 11

Просмотреть онлайн или скачать pdf Руководство по установке и эксплуатации для Контроллер AGS Parksafe Control Panel. AGS Parksafe Control Panel 16 страниц. Ventilation control panel
Также для AGS Parksafe Control Panel: Руководство по установке и эксплуатации (16 страниц), Установка, эксплуатация и обслуживание (16 страниц), Руководство по установке, эксплуатации и техническому обслуживанию (20 страниц)

Installation & Operation Manual

OPERATION

Upon connecting mains power, the Parksafe control panel will load for approximately 60 seconds.

During this time the screen will display an 'initialising' screen. The panel will then begin establishing

signals with any Parksafe gas detectors.

Home Screen Status & Condition Overview

System OK.

Under normal/safe conditions.

System in 'Pre-Alarm' condition.

When detected gas reach pre-alarm levels.

OUTPUT 1 relay: activated.



0-10V output: 5V



Other relays and external devices may activate if configured to do so.

System in 'Alarm Delay' condition.

When detected gas reach dangerous alarm levels.

OUTPUT 2 relay: activated.



0-10V Output: 10V



Other relays and external devices may activate if configured to do so.

System in Alarm condition.

When gas levels remain dangerous beyond the alarm delay.

ALARM relay: activated.



Gas detector ID appears on screen.



The internal buzzer will sound to alert the user.



The detector ID of the first signal received will be displayed on screen only.

Temperature Status & Icon

This feature is factory set to off.

If enabled and the temperature levels detected exceed a

selectable threshold, the temperature icon appears and the

system enters an alarm state.

All relays/outputs will activate until the temperature (detected by

Parksafe Detectors) drops below the specified threshold –

adjustable in the configuration settings menu.

AGS Parksafe Panel - IOM Iss: 6 10-20

Parksafe