Hikari H93S Руководство по эксплуатации - Страница 8
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Контроллер Hikari H93S. Hikari H93S 20 страниц. Electrical control box
Печатать страницу
will run several times， and then angle data will appear on the screen， it means motor sensor angle data。
Press
key could return back to normal mode from current mode。
Remark：The function used for needle stop un-usual or check whether the parameter data of
sensor angle is correct or not when high speed stitching。
Step zero setting：
Under normal sewing mode, long press
press
key exchange to"
appear"P-75—00"，press
parameter，press
Press
key could return back to normal mode from current mode。
5.2 Pedal zero position setting mode：
Under normal sewing mode, long press
press
key exchange to "3-Pd"， press
appear "pdL"，now the system will checking by it self，waiting 3 seconds，the screen appear "PASS"，
if self-checking is fault， the screen will appear error code no。 Press
mode from current mode。
Remark： The function is used for pedal running error， adjust the parameter data through software
program。
6. Resetting mode：
Under normal sewing mode，long press"
parameter no. "P79" ， press"
【press"
"key could adjust to "no"】 ，and then press"
Hotkey for resetting：Under normal sewing mode，long press
"yes"【press"
7. Copy original parameter and resetting original parameter。
Under normal sewing mode，long press"
parameter finish setting，enter parameter no. P131，appear "0"，press
press
key for confirm，that's all for save original parameter。
" ， press
2-bJ
key exchange P-75/P6/P7/P8 circle，press
key adjust data，press
"key and adjust to "8" ， appear "yes" after press "S" key
"key will adjust to "no"】 ，and press "
key 3 seconds ， screen appear "1-dJ" ，
key enter machine zero position interface ，
key for confirm and exit current interface。
key 3 seconds ， screen appear "1-dJ" ，
key enter pedal zero position interface， the screen
"key enter parameter interface，appear "0" when enter
"key for confirm。
"key to confirm the data resetting。
"key enter parameter interface， whole machine
5
key enter current
key could return back to normal
key over 1.5 seconds，appear
key exchang to "1"，and