AGS PARKSAFE GAS DETECTOR Установка, эксплуатация и обслуживание - Страница 5
Просмотреть онлайн или скачать pdf Установка, эксплуатация и обслуживание для Детекторы газа AGS PARKSAFE GAS DETECTOR. AGS PARKSAFE GAS DETECTOR 16 страниц.
Печатать страницуInstallation, Operation & Maintenance
Mounting
Unpack all the parts!
Designed for surface mounting, it must be installed by a licensed, insured contractor.
1. Carefully remove the front cover of the unit by removing the four screws with a screwdriver.
2. Remove the foam, this is used for transit purposes only.
3. Using the rear cover - mark the screw holes to the wall. If mounting direct to wall - ensure the wall
surface is flat to prevent base distortion.
4. There is a 0.79" diameter hole for cable entry.
5. Position as per the recommended heights and in accordance with applicable regulations.
6. After executing the mounting, connections and ID switches – secure the front cover.
Board Overview
Wiring of different circuits shall be separated by means of routing, clamping or barrier!
All Class 2 wiring is to be installed within flexible tubing to maintain segregation between circuits!
A shielded cable is used for all wiring!
Any damage attempting to remove the circuit board parts may void any warranty!
Do not remove the Gas Sensor Module when the detector is powered!
Rev: 9 10-20
Parksafe Gas Detector
5