Coram Showers OPTIMA Руководство - Страница 2

Просмотреть онлайн или скачать pdf Руководство для Сантехника Coram Showers OPTIMA. Coram Showers OPTIMA 2 страницы. Extender pack
Также для Coram Showers OPTIMA: Руководство (16 страниц), Руководство (2 страниц)

Печатать страницу
Check contents of pack before installation. If anything is
missing, contact our Customer Careline for assistance.
CUSTOMER CARELINE: 01746 713410
PN3222
PN50495
PN50496
3
10mm
PN4748
PN50503
PN50504
3
1
a
=
=
ø 4.5
mm
=
100mm
max
a: Drill holes in both wall channels at points shown using a 4.5mm drill bit, where shown.
b: Ensure the shower tray is level in all directions. IMPORTANT: Clean the tray and seal the gap between the tray surface and tiles. It is important
that the tray is sealed right up to the tray edge so that the bottom of the wall channel is sealed. Failure to do this will cause water to leak under
the wall channel and between the tray and tiles, resulting in damp patches on the wall and under the tray.
2
a
X
3mm
min
X = Side Panel (S/P) widths
a: Place wall channels on the tray ensuring they are vertical and a minimum of 3mm back from the front of
the tray. Place masking tape against the wall before marking drill hole positions, this will help prevent the
700 S/P = 670 - 695mm
drill bit slipping. Drill 6.5mm holes, 30mm deep and insert the wall plugs.
760 S/P = 735 - 760mm
800 S/P = 775 - 800mm
b: Apply sealant to the back of the wall channels.
900 S/P = 875 - 900mm
c: Fix the wall channels to the wall using 8 x 32mm screws and screw caps.
2
1/1
1/1
b
100mm
max
b
c
ø 6.5
ø 6.5
mm
mm
3
a
4
a
a: Check that the enclosure is perfectly vertical and the door is square within the frame (see Door instruction).
b: Drill inside of wall channels and corner post using 3mm drill bit in the 5 positions shown. DO NOT drill too deep.
Fix using 10mm screws and screw caps.
c: Check that the enclosure is perfectly vertical and the door is square within the frame. Drill the next four holes in the upper positions shown
inside of the wall channels and corner post using 3mm drill bit.
DO NOT drill too deep. Fix using 10mm screws and screw caps.
32mm
b
b
ø 3
mm
10mm
a: Insert your door into the wall
channel (Pivot Door shown).
b: Insert the side panel into the
wall channel and into the door.
c
ø 3
mm
10mm
3