Dynojet 1139.005 Краткое руководство по эксплуатации - Страница 2

Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Аксессуары для мотоциклов Dynojet 1139.005. Dynojet 1139.005 2 страницы.

STAGE ONE INSTRUCTIONS

1. Remove the vacuum slide from the carbs. Remove the stock needles & spacers,

noting the order of assembly. Locate the slide lift holes using (Fig. A). Using the

DD#7/64 drill bit provided drill both slide lift holes.

2. Locate the Dynojet part# DNJT02 supplied. With cutaway facing up and to the

engine (Fig. B), use the shroud tool provided (DT007) to press over stock needle

jet. Before pressing down add a touch of glue to the outer base of the stock needle

jet, then press down. Check to make sure there is no excess glue visible.

3. Install the Dynojet needles on groove #3, using all stock spacers. Install the

Dynojet washers above the E-clip.

4. Remove the stock main jets and replace with Dynojet main jets provided. If

you are running the stock exhaust use the DJ120 main jets, if you are running

an aftermarket header or slip-on with high flowing baffle, use the DJ124 main jets.

Be sure that the jet you are changing is the main jet.

5. Locate the fuel mixture tab (Fig. C), carefully turn mixture tab clockwise until

they seat, turn out 2 turns.

NEEDLE HOLE

SLIDE LIFT HOLES

Fig. A

1139.005

Place E-clip

in groove #3

from the top

Fig. C

Fig. B