CORBERO FDE 3170 I Буклет с инструкциями - Страница 5

Просмотреть онлайн или скачать pdf Буклет с инструкциями для Холодильник CORBERO FDE 3170 I. CORBERO FDE 3170 I 10 страниц.

Печатать страницу

Important

The centre hinge can be moved horizontally by about

3 mm to allow alignment of the doors, as follows:

slacken the two screws securing the centre hinge to

the cabinet and move the hinge until the doors are in

line. Re-tighten the hinge securing screws.

Warning

Once the opening direction of the doors has been

changed, check that the magnetic seal adheres to the

cabinet.

If the ambient temperature is cold (for example in win-

ter), the seal may not adhere perfectly to the cabinet.

In this case, wait for the seal to adapt naturally to its

new position, or accelerate this process by heating up

the area involved with a normal hairdryer.

Building and securing the appliance into

the tall kitchen unit

Recess

height

1446 mm

550 mm

Recess characteristics (Fig. 1-2)

D140

of the appliance, and through an opening to be cut in

the base of the kitchen unit (minimum size 200 cm

Fig. 1).

D010

Recess

depth

width

560 mm

Fig. 1

The dimensions of

the recess for ﬁt-

ting the appliance

into a tall kitchen

unit must be as in-

dicated in the table

above.

200 cm

Ventilation is pro-

vided though the

bottom grille, se-

cured to the bottom

Fig. 2

A vent outlet, 50

mm deep by 540

mm wide must be

cut in the top of

the unit (Figs. 1-2)

Warning

A top seal is supplied loose with the appliance; this

seal must be ﬁtted before inserting the appliance into

the recess (the holes for ﬁxing it are pre-drilled).

A plastic edging strip, with a double-sided adhesive

strip on the inner side, is also supplied.

D030

between the edge of the appliance cabinet and the in-

side of the kitchen unit recess.

Fitting the appliance into the recess (Fig. 4)

To position and secure the appliance inside the re-

cess, proceed as follows:

D117

front of the recess (Fig. 1).

Using the 6 screws provided, secure the bottom venti-

lation grille and the top seal (the holes are pre-drilled).

Fig. 3

Remove the back-

ing from the edg-

ing strip, then stick

it vertically onto

the front edge of

the appliance, on

the side on which

t h e d o o r o p e n s

(Fig. 3).

Fitting this strip

eliminates any gaps

Fig. 4

position the appli-

ance inside the tall

kitchen unit, push-

ing it against the in-

ner side of the unit

on which the door

opens

make sure that, with

the door closed,

the appliance is set

back 8 mm from the

(Fig. 4);