Main Mitre-AS Руководство по установке и обслуживанию - Страница 4
Просмотреть онлайн или скачать pdf Руководство по установке и обслуживанию для Котел Main Mitre-AS. Main Mitre-AS 18 страниц. Gas fired -instantaneous sink water heater
Печатать страницуPull handles and knobs from front of appliance.
Remove the two fixing screws 1.
Fig. 1
.
Carefully swing out bottom edge of case front to clear tap spindles. Disconnect wire lead from
rear of spark igniter and lift off case front. Deter-mine the correct position for the heater taking
into account instructions given under "VENTI-LATION AND AIR SUPPLY".
Place appliance in position on the wall and mark the wall for top fixing point.
Drill hole in wall using an 8mm. drill and insert plastic plug. Screw stud into plug down to the
depth of the threads. Remove any burrs from screw. Place appliance on the wall ensuring that
the stud engages into the fixing hole in rear of appliance. Using a spirit level ensure that the
appliance is vertical temporarily tighten the grub screw at the top rear of the appliance case.
Hold clips in position towards outside edge of slots as shown in
Fig. 2
and mark wall. Slacken
grub screw and lift off appliance. Drill and plug wall to take clip securing screws. Place appliance
into position on wall, tighten grub screw and secure at bottom using the fixing clips.
WATER INLET CONNECTION
It is strongly recommended that the use of loose jumper washer type cocks be avoided.
Flush out all foreign matter from the supply pipe before connecting to the appliance.
Connect copper tail and sealing washer to water service cock 2.
Fig. 3
and connect water supply
using 15 mm. copper pipe to B.S. 2871.
IMPORTANT. Remove the sealing washer from copper tail before making any soldered joints to
prevent damage from heat. Replace washer on completion.
WATER OUTLET SHORT SPOUT (WHERE APPLICABLE)
Connect short spout and sealing washer 4
Fig. 3
to water outlet 3
Fig. 3
.
IMPORTANT: Remove swivel spout if already fitted.
SWIVEL SPOUT CONNECTION (WHERE APPLICABLE)
Connect swivel spout and sealing washer 4.
Fig. 3
to water outlet 3
Fig. 3
.