Dynojet GSX1300R Инструкции по установке - Страница 2

Просмотреть онлайн или скачать pdf Инструкции по установке для Контроллер Dynojet GSX1300R. Dynojet GSX1300R 3 страницы. Fuel controller for 2008 suzuki

Печатать страницу
Unplug these connectors
Wire tap
Grey wire from PCIII
i339-411
www.powercommander.com
1
Remove the main seat and the passen-
ger seat.
2
Hold the front of the fuel tank up
using the prop rod located
in the trunk area.
3
Disconnect the main wiring harness
from each of the LOWER injectors
(Fig. A).
4
Lay the PCIII in the tail section and
route the PCIII harness down the left
hand side of the bike towards the
throttle bodies.
5
Plug the PCIII wiring harness in-line
of the stock wiring harness and injec-
tors (Fig. B).
Cylinder 1 - ORANGE
Cylinder 2 - YELLOW
Cylinder 3 - GREEN
Cylinder 4 - BLUE
6
Locate the Throttle Position Sensor
connector on the right hand side of
the throttle body.
7
Crimp the supplied wire tap to the
PINK/BLACK wire of the TPS har-
ness.
8
Connect the GREY wire from the
PCIII to the wire tap (Fig. C).
It is recommended to use dielectric
grease on these connections.
2008 Suzuki Hayabusa - PCIII USB - 2