AGS Merlin 1000S Руководство по эксплуатации и установке - Страница 7

Просмотреть онлайн или скачать pdf Руководство по эксплуатации и установке для Лабораторное оборудование AGS Merlin 1000S. AGS Merlin 1000S 10 страниц. Gas utility isolation controller
Также для AGS Merlin 1000S: Руководство по установке, эксплуатации и техническому обслуживанию (10 страниц), Руководство по установке и эксплуатации (12 страниц), Руководство по установке и эксплуатации (16 страниц)

Merlin 1000S

Gas Utility Controller

EM STOP

If an emergency shut off button (either remote or on the panel) is pressed, the LED will

illuminate and the gas will be shut off. The EM Stop button must be re-set before restarting

the system.

OFF = OK

AMBER = EM Stop button pressed

GAS DETECTED

Under normal working conditions this LED is off.

If the external Merlin detector connected detects gas this will illuminate and the gas valve

will shut off.

OFF = OK

RED = Gas detected.

CO2 HIGH

Under normal working conditions this LED is off.

If the concentration of CO

LED will illuminate and the gas valve will shut off.

OFF = OK

RED = the concentration of CO

Emergency Shut Off Use

The Emergency shut off button is located on the front of the panel. There is also a facility

for remote shut off buttons to be wired in series.

The Emergency shut off button(s) will cut off the gas supply when activated.

To reinstate the system, the Emergency shut off button(s) will need to be reset and the

panel restarted.

The Merlin 1000S can be integrated with a BMS to make or break a

circuit on gas on/gas off, (valve open or valve closed). This will tell

the BMS whether or not power is being sent to the solenoid.

There is a dip-switch located on the inside facia of the Merlin 1000S

labelled [BMS SELECTION]. This is factory set in the 'off' position

which signals the BMS on gas on/gas off.

When switched to the 'on' position, the 1000S will only signal the

BMS on a fault, i.e. CO2 high level detected, gas detected, EM Stop

pressed, etc.

The Merlin 1000S can be integrated with a fire alarm to shut the gas supply automatically in

the event of a fire. The volt free fire alarm signal can be wired in series with any remote

emergency shut off buttons.

If there are no remote emergency stop buttons installed, wire this directly to the terminal

marked [EM REMOTE].

Rev: 04 Date: 15-08-18

in the air is at alarm level (relevant detector required), the

is at alarm level.

User & Installation Manual