AGS Merlin 1000S Руководство по установке, эксплуатации и техническому обслуживанию - Страница 5

Просмотреть онлайн или скачать pdf Руководство по установке, эксплуатации и техническому обслуживанию для Лабораторное оборудование AGS Merlin 1000S. AGS Merlin 1000S 10 страниц. Gas utility isolation controller
Также для AGS Merlin 1000S: Руководство по эксплуатации и установке (10 страниц), Руководство по установке и эксплуатации (12 страниц), Руководство по установке и эксплуатации (16 страниц)

Merlin 1000S

Gas Utility Controller

2.9

FS 1/2/3/4 [7]

This terminal switches when the key is turned on and off.

This can be linked to a fan switch (panel supplied separately) which can provide power to fans

when the control panel is switched on.

2.10

CO2 MONITOR [8]

This terminal can be wired to CO

If no CO

monitor is supplied leave the terminal link in [

For more information, consult the CO2 Monitor manual.

2.11

This is a permanent 12v DC output when there is power at the panel and can be used to

create a relay switch with the BMS relay output.

Please contact your supplier for further information.

2.12

Operates at 65dB measured 30cm from closed panel.

2.13

The Merlin 1000S has a built-in Auto-shut down feature and it will turn itself off after a predefined

time. Auto-shut down timeout is selectable.

There are two Dip-Switches located on the inside facia labelled [Time1] and [Time2].

The gas supply will be cut off at desired time-out.

To select required timeout – configure Dip Switches as follows;

2 HOURS (FACTORY SET)

Time1 Off / Time2 Off

4 HOURS

Time1 On / Time2 Off

8 HOURS

Time1 Off / Time2 On

NO TIMEOUT

Time1 On / Time2 On (auto-shut down disabled)

3.1

SYSTEM ON & OFF

Turn off all open appliances.

Turn the key switch to on position.

To turn the system off, turn the key switch to off position.

Rev: 05 Date: 29-10-18

monitor to shut off the system in the event of High CO2 levels.

User & Installation Manual