Gama Garden GLM-43E Руководство по эксплуатации - Страница 8

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Газонокосилка Gama Garden GLM-43E. Gama Garden GLM-43E 10 страниц.

Do not rapidly switch off and on.

starting:

1. Press and hold the safety button 1.

2.Squeeze the switch lever 2 towards the handle.

3.Release the safety button 1.

Stopping:

Release the switch lever 2.

Mowing :

Place the lawnmower on the edge of the lawn, as close to the power point as possible. Work away from

the power point

Position the cable to opposite side(already cut)at the end of each turn.

When mowing do not allow the motor to labour particularly in heavy conditions. When the

motor labours the speed of the motor drops and you will hear a change in the motor sound, when

this occurs stop mowing, release the switch lever and raise the height of cut. Failure to do so

could damage the machine.

NOTE: The motor is protected by a safety cut out which is activated when the blade becomes

jammed or if the motor is overloaded. When this occurs stop, remove the plug from the power supply.

The safety cut out will only reset when the switch lever 2 is released. Clear any obstruction and wait

for a few minutes for the safety cut out to reset before continuing to use the mower. At this time do not

operate the switch lever 2 as this will prolong the reset time of the safety cut out. If the mower cuts out

again increase the height of cut to reduce the load on the motor.

Maintenance

Cleaning

Note: Disconnect electricity by unplugging cable at the socket before proceeding. Attention:

keep hands clear of moving blade.

Clean mower thoroughly after each mowing with cloth or brush.

Do not spray with water.

Winter storage

. Clean mower thoroughly before storing away.

. Have your mower thoroughly checked once a year by an approved service center

. Do not store it in a wet or hunid place.

.Keep all nuts, bolts, and screws tight to be sure the appliance is in safe working condition.

.Check the grass catcher frequently for wear or deterioration.

.Replace worn or damaged parts for safety.

Stop, remove plug from the power

supply and remove the collector.

Turn the machine on its right side and inspect the blade L06 and fan; if blunt or damaged, replace .

Use the following procedure to remove and replace the blade. Hold the blade using gardening gloves(not provided)

use a spanner(not provided)to remove the blade bolt, fan and blade. Fit the fan, blade and blade bolt. Ensure that

the blade is the correct way up and tighten the bolt firmly.