Gama Sonic GS-104 Руководство по эксплуатации - Страница 3
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Наружное освещение Gama Sonic GS-104. Gama Sonic GS-104 5 страниц. Pagoda solar lamp post
Печатать страницу
Tools that are needed but not supplied with the high post lamps are: a screw driver, a
wrench and an electrical drill that will be used to anchor the lamp base to the ground.
Solar Lamp Post Location
For optimum light duration throughout the night, it is very important to mount your
solar lamp post in a spot where it will receive the maximum amount of sunlight
throughout the day.
NOTE: The following steps are for reference only. Consult your local hardware store
for the best installation method for your particular surface.
NOTE: The solar light must be charged for two sunny days for best results.
Operation Instructions for all models
1. Unscrew the two knobs on the lamp top (B) to detach it from Part A.
2. Turn ON the operation switch by choosing your desired brightness
level: Low (I) - last longer using dimmer light. High (II)- Brighter
light output. (Fig. 1).
3. Reassemble the upper part of the lamp (B) by screwing the two knobs.
Installation Instructions for models GS-104S\D
1. Mark and drill three holes, into a solid surface no smaller than the
fastening screws. The holes shall be lined up with the holes of the
lamp base (D).
2. Put the fastening screws (included) into the drilled holes with their
threaded ends facing up (Fig. 3).
3. Place lamp base onto fastening screws and secure base with the nuts
using a wrench (Fig 4).
4. Make sure the lamp base (D) is stable before installing Part (E).
5. Place part (E) on top of part (D) and tighten with the provided screws
using a wrench.
6 GS-104S:
7.1 Screw part (G) onto part (E) and part (F) onto part (G).
7.2 Place Part (A) on top of Part (F) and tighten the 3 screws.
8. GS-104D:
8.1 Screw part (G) onto part (E).
8.2 Screw Part (H) onto Part (G).
8.3 Place bracket (I) into part (H) and tighten the knob with the nut
provided from within Part (H), then screw the second screw from
outside Part (I) to secure the bracket to part (H).
8.4 Repeat steps (8.3) two times in model GS-104D.
8.5 Install part (J) on top of Part (H) by screwing the two screws.