Gama Sonic 124B50071 Руководство по эксплуатации - Страница 3

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Фонарь Gama Sonic 124B50071. Gama Sonic 124B50071 4 страницы. Aurora bulb post lamp with ez anchor

Печатать страницу

Assembly Instructions

1. Remove the EZ anchor plate (G) from the base

pole (F) by removing the cap nut, nut, and

washer from each of the three studs.

2. If Installing the lamp using the EZ anchor,

position the auger (H) where you want the

lamp to be. (If installing without the anchor,

skip to step 6b)

3. Using the turning bar (I), turn the auger (H) into the ground

clockwise.

Note: For areas with hard dirt, moisten the ground with water to make

installation easier.

4. Make sure the auger goes in straight by using the level bubble at

the top. Stop once the ring is flush with the ground.

5. Place the EZ anchor plate (G) over the auger (H) and secure using

the large nut and bolt.

6. Secure the base pole (F)

a. If using the EZ anchor, slide the base

pole (F) over the EZ anchor plate (G).

Secure using the provided washer,

nut, and cap nut for each of the

three studs.

b. If not using the EZ anchor and securing

into concrete, using the base pole (F) as a

template, mark and drill three holes.

i. Place the anchors into the holes and secure the

base pole (F) by tightening the anchors.

7. Attach the middle pole (E) to the base

pole (F) and secure using the

three screws.

8. Attach the top pole (D) to the

middle pole (E) by twisting clockwise.

9. Attach the spacer pole (C) to the top pole (D) by

twisting clockwise.

10. Attach the fixture (B) to the spacer pole (C) by twisting

clockwise.

11. Insert the GS Solar LED bulb into the top (A) by twisting

clockwise. Be sure to hold the bulb by its base and not

the glass.

12. Turn the lamp on and secure the top (A) to the fixture

(B) using the provided screws.

page 3

Operation Instructions

Install the GS Solar LED Bulb into the Top (A).

Locate the operation switch on the underside of the Top (A).

Switch the lamp to either the Low or High setting according to your

preference:

Low = Softer light output and longer duration

High = Brighter light output

The lamp will operate automatically at dusk.

Replacement Parts

Replacement Batteries and Bulbs are available at

www.gamasonic.com or via our Toll Free number: +1-800-835-4113

Your Lamp can use the following bulbs:

A50WW10W – included bulb with Warm White LEDs (2700K)

A50BW10W – bulb with Bright White LEDs (6000K)

F30WW05W – included Flame bulb with simulated flame LEDs

T45WW10W – Edison LED Bulb with Warm White LEDs (2700k)

Your Lamp uses the following battery:

GS32V15 – Li-Ion 3.2V/1500mAh