Frigidaire Smart Choice 5304493868 Руководство по установке - Страница 2
Просмотреть онлайн или скачать pdf Руководство по установке для Посудомоечная машина Frigidaire Smart Choice 5304493868. Frigidaire Smart Choice 5304493868 10 страниц. Deluxe dishwasher install kit
Печатать страницу
Installation
Faucet
Hot water
Supply
Riser Tube
Water
Supply T
Commpression
Fitting
Hot Water
Valve
Garden
Dishwasher
Hose Elbow
Waterline
1. Waterline Connection
IMPORTANT
• Turn off both hot and cold water supply lines.
• Do not over tighten connections.
A. Locate the hot and cold water supply lines under the kitchen
sink.
B. Disconnect the kitchen faucet hot water riser tube from the
shut off valve.
C. Install the water supply T compression tube fitting on the end
of the hot water faucet riser tube.
D. Connect the water supply T compression fitting to the hot
water shut off valve.
E. Connect the braided stainless steel waterline to the water
supply connection.
2. Dishwasher Connection
Determine the type of water fill valve used on your dishwasher:
• If the valve has a ⅜" threaded connection, follow steps A
through E.
• If the dishwasher has a hose bib connection, follow steps F
though J.
• Do not overtighten.
3-Prong Grounded
Wall receptacle
or
Plumber' s Sealant
Tape Here only
⅜" Threaded
(Around threads on
Elbow
⅜" Elbow)
Green Wire
(Ground)
⅜" Threaded Connection
A. Wrap the threads of the elbow with two turns of sealant tape
provided in the kit to ensure a leak-proof connection.
B. Connect and tighten the threaded end of the elbow to the
inlet water valve on the dishwasher.
C. Run the braided stainless steel waterline to the underside of
the dishwasher.
D. Remove and discard the compression nut and compression
ferrule from the elbow installed in step B.
E. Connect the ⅜" compression nut on the braided stainless
steel waterline to the elbow installed in step B above.
Garden Hose Connection
F. Verify that the hose washer is in the elbow before installing.
G. Connect the garden hose elbow to the dishwasher inlet
valve. Do NOT use the sealant tape on the dishwasher inlet
valve.
H. Hand tighten the garden hose elbow on the dishwasher inlet
valve and add a ¼ turn.
I. Run the braided stainless steel waterline to the underside of
the dishwasher.
J. Connect the ⅜" compression nut on the braided stainless
steel waterline to the elbow installed in step G above.
Strain Relief
Green Wire
(Ground)
Black or Smooth
(Hot) Connects to
Black dishwasher
wire
White or Ribbled
(Neutral) wire
connects to white
dishwasher wire