Adesys SVM Series Руководство - Страница 11
Просмотреть онлайн или скачать pdf Руководство для Модем Adesys SVM Series. Adesys SVM Series 18 страниц.
Печатать страницуAdesys B.V. | Wateringen
3.7.
System
In the system section you can change the general SVM settings, enter GSM and mobile data settings or
trigger a factory reset.
3.7.1. Device
In this window you can change device-specific settings such as device name, alarm active text, alarm
recovered text, automatic updates and a periodic reset.
3.7.2. Ethernet
Ethernet can be set up with a DHCP server or with the IP, DNS and gateway entered by the user.
3.7.3. GSM and mobile data
Here, the GSM module can be switched off, the PIN code entered, 2G/4G mobile data switched off and
locked. You here also will find APN set up. Please contact your provider for the APN settings.
3.7.4. Factory reset
By performing a factory reset all settings will be lost and a reset to the default settings will be prompted.
4.
Notification procedure
The notification procedure starts in the event of a status change or error. If set up, the SVM will first
establish a data connection and send data, and then send the associated notification message to the first
contact on the call list that has been set up.
4.1.
Notification message
An SMS or Email alarm message is structured as follows: Device name | input name | status.
• Device name: contains a text chosen by the user. This can be set up in the system menu.
• Input name: contains a text chosen by the user, which is coupled to the input channel. This can be set
up in the I/O menu for the relevant input.
System errors such as the Ethernet error and the 'no numbers coupled' error have a fixed text (in English)
that cannot be changed. For example, powerfailure is used for a mains power failure.
• Status: shows whether an input channel is Active or Idle. Active and recovery texts can be set up in the
system menu.
4.2.
External server application message (Clientmode)
The SVM can connect to another system remotely. This remote system is called the external server
application. This could be a SCADA system, for example.
If set up, the SVM will send a message to an external IP. This can be set up in the Modem Clientmode
window and can again only be used if clientmode is active. The message is structured as follows:
#<Device name><InputNo><InputName><Status>#
Example message: <Adésys><1><Input1><Active>
4.3.
Notification of status changes
After input channel 1 has been activated, the following can be observed:
• The green LED (on/busy) flashes 1x to indicate that input channel 1 is active;
• After a few seconds, the green LED (on/busy) flashes faster to indicate that the SMS message is being
sent;
• The green LED (on/busy) again flashes 1x. The SMS message has been sent;
• The notification message appears on the mobile phone to which the SMS message has been sent; this
message can be structured as follows: LOCATION PUMP FAULT Active;
• The green LED (on/busy) continues to show the status of the input until this ceases to be active;
• If the input returns to idle mode and a recovery report has been set up, the notification message will be
structured as follows: LOCATION PUMP FAULT Idle.
Manual SVM 4G modem | Back to
Index
Figure 2 Notification procedure
Page 11