Adesys SVM Series Руководство - Страница 6

Просмотреть онлайн или скачать pdf Руководство для Модем Adesys SVM Series. Adesys SVM Series 18 страниц.

Adesys B.V. | Wateringen

Connection

To connect the SVM correctly, we recommend using exclusively Camden CTB922HE/# type connectors.

Measurements may be affected if other connectors are used.

2.1.

Positioning

Position the SVM where it is not affected by direct sunlight or other heat sources. Choose the place of

installation such that moisture cannot penetrate the device. The SVM can be mounted onto the TS35 rail

without screws. The permitted ambient temperature range for the electronics is -20°C to +50°C.

The transmission power of the SVM's internal GSM/4G module is higher than that of a standard mobile

phone. Under certain conditions this may affect the functioning of surrounding electronic equipment. The

effects depend upon the distance between the antenna and surrounding equipment.

2.2.

Affixing and removal: DIN rail

The SVM should be affixed to a DIN rail before connection.

• Put the SVM onto the DIN rail at an angle [1]. It is important that the SVM's DIN rail clip is positioned on

the top of the DIN rail.

• Tilt the SVM to clip it into place [2]. Then check whether it is securely seated.

The SVM is removed from a DIN rail as follows:

• Place a screwdriver on the underside of the DIN rail clip [3]. Use this as a lever; after approx. 3 mm the

SVM can be tilted to release it from the DIN rail.

2.3.

SIM card

If the SIM card has a PIN code, this should be entered in the setup tool SV-prog. The required SIM card is

installed as follows:

• Switch the SVM off by disconnecting the supply voltage, then press and hold the reset key for 8 seconds

to switch off the dialler;

• The SIM card holder is made accessible by pressing the button next to it using a sharp object. The

holder is then pushed outwards;

• Place the SIM card in the holder and slide this back into the SVM;

• Reconnect the supply voltage to switch the SVM on.

The SVM should be completely switched off before the SIM card is installed. Fitting or removing the SIM

card with the SVM switched on may damage the SIM card.

Manual SVM 4G modem | Back to

Index

Page 6