MAINLINE ML100W Инструкции по установке Уход и обслуживание

Просмотреть онлайн или скачать pdf Инструкции по установке Уход и обслуживание для Туалеты MAINLINE ML100W. MAINLINE ML100W 11 страниц. Round front toilet

Печатать страницу

Round Front Toilet

Devant de cuvette rond

Installation Instructions, Care and Maintenance

For model: ML100W / ML125W / ML135W bowls

Thank you for selecting Mainline.

To ensure this product is installed properly, please read these instructions carefully

before you begin.

(Certain installations may require professional help.)

Also be sure your installation conforms to local codes.

CAUTION:

PRODUCT IS FRAGILE.

TO AVOID BREAKAGE AND POSSIBLE INJURY, HANDLE WITH CARE!

Recommended Tools and Materials:

• Putty Knife

• Wax Ring/Gasket

• Closet Bolts

Remove Old Toilet

a. Close toilet supply valve and flush tank completely.

Towel or sponge remaining water from tank and bowl.

b. Disconnect and remove supply line.

NOTE: If replacing valve, first shut off main water supply!

c. Remove old mounting hardware, remove toilet and plug floor waste

opening to prevent escaping sewer gases.

d. Remove closet bolts from flange and clean away old wax, putty, etc.

from base area.

NOTE: Mounting surface must be clean and level before new toilet is

installed!

Roughing-in Dimensions

NOTE: Distance from well to closet flange centerline. - 12" (305mm)

Install Closet Bolts

Install closet bolts in flange

channel, turn 90° , and slide

into place 6" (152 mm) apart

and parallel to wall.

• Screwdriver

• Adjustable Wrench

• Flexible Supply Tube

VITREOUS CHINA

• Sealant

• Level

Install Wax Seal

Invert toilet on floor (cushion

to prevent damage), and

install wax ring evenly around

waste flange (horn), with

tapered end of ring facing

toilet. Apply a thin bead of

sealant around toilet base.

Position Toilet on Flange

a. Unplug floor waste opening and

install toilet on closet flange so

bolts project through mounting

holes.

b. Loosely install retainer washers

and nuts. Side of washers

marked "THIS SIDE UP" must

face up!

Install Toilet

a. Position toilet squarely to wall and, with

a rocking motion, press bowl down fully

on wax ring and flange. Alternately

tighten nuts until toilet is firmly seated

on floor.

CAUTION: DO NOT OVERTIGHTEN NUTS

OR BASE MAY BE DAMAGED!

b. Install caps on washers. (If necessary,

cut bolt height to size before installing

caps.)

c. Smooth off the bead of sealant around

base. Remove excess sealant.

• Tape Measure

• Hacksaw