aireRyder Cyrus Инструкция по установке и использованию - Страница 3
Просмотреть онлайн или скачать pdf Инструкция по установке и использованию для Вентилятор aireRyder Cyrus. aireRyder Cyrus 6 страниц.
Печатать страницу
Fig.1
Turn off the electric circuit at the
main fuse or circuit breaker box.
Support Pin
Fig.3
Lock Pin
Hanger Pin
Remove the lock pin and take off
the hanger pin.Then remove screw
and slide the ball joint down to take
off support pin.
Fig.6
Collar Screws
Insert and tighten the two collar
screws. Slide lock pin into hanger
pin.
Fig.8
N
L
Male Connector
Male Terminal
Female Terminal
Female Connector
Fixture Wire
F
A
N
C
O
161031
Hanger
Bracket
Flat Washer
Spring Washer
Fig.2
Fig.4
Ball Joint
Screw
Motor Wires
Thread the motor wires through the
downrod stand cover, canopy and
downrod.Then restore support pin
and downball back by tightening
screw.
Fig.7
Lock Pin
From House Wire
Terminal Block
House Wire
Attach the hanger bracket to the ceiling
with spring washers, flat washers and 2
mounting screws.
Note: For sloped ceiling installation, make
sure that the hanger bracket is installed
Guide Pin
so that the guide pin is facing upward.
Downrod
Canopy
Downrod Stand
Cover
Hang the fan on hanger bracket,
Hanger Bracket
and make sure the slot of ball joint
is fitted into the guide pin of hanger
bracket.
Slot
Guide Pin
1. Make house wire connections. Follow diagram on
the left and make sure that all exposed wires are
tightened by screw on terminal block.
Note:
a.) The terminal block shown in left graph is
pre-installed on the mounting bracket.
b.) After wiring is completed, gently push wires into
hanger bracket with terminal block facing upward (if
applicable).
2. Make fixture wire connection. Plug the male
connector into female connector and plug the male
terminal into female terminal.(Do not force
it into wrong receptacle as it will cause damage.)
Fig.5
Downrod Stand
Cover
Motor Wires
Hanger Pin
Loosen the collar screws partly.
Insert the downrod into the collar.
Slide hanger pin through holes of
collar and downrod and secure with
lock pin.
Downrod
Canopy
Collar