Mains MV4k/1 Руководство по эксплуатации - Страница 15
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Контроллер Mains MV4k/1. Mains MV4k/1 18 страниц. Checkout controller
Печатать страницу
Controller MV4K - programming functions
Programing the operating modes MV4
Service mode: 1 (diagnostic)
If the controller is turned on, press the button [2] for about 6 seconds. SERVICE LED should light up.
In this mode, the controller sends audio signals helping to diagnose a possible problem.
If the photocells do not see each other, we can hear modulated signal.
Intermittent signal determines a short circuit or other damage of the footswitch circuit.
Service mode 2
SOFT START
Turn off pulsed light
MAINS S.C. E.M.Wosińscy Brzeziny 95-060 ul. Słowackiego 12, tel/fax: 48 46 8752 777 www.mains.pl; [email protected]
Digital programmable belt controller
Service mode 2 is switched on while being in the service mode 1
by pressing the button [2] for about 3 seconds.
S.START LED should light up.
The "soft-start" function is switched on while being in the service mode 2
by pressing the button [1].
The S.START LED starts flashing, it means the „soft-start" function is active.
To turn off this function, press again the button [1].
In the service mode 2 is possibility to switch off the pulse lamp mode
by pressing the button [3].
OUT diode starts flashing, it means the lamp is in the constant mode.
By pressing second time the same button, the constant mode is turned off.
SERVICE
S. START
2
OUT
CTRL
POWER
POWER
Programming functions
Mv4k
SERVICE
S. START
2
OUT
CTRL
SERVICE
S. START
2
OUT
CTRL
SERVICE
S. START
2
OUT
CTRL
controller: Mv4k
15