GAME SolarPRO XD3 Руководство пользователя - Страница 7

Просмотреть онлайн или скачать pdf Руководство пользователя для Нагреватель для плавательного бассейна GAME SolarPRO XD3. GAME SolarPRO XD3 12 страниц.

Печатать страницу

1. Parts List/Reference

SKIP B and GO TO 3

B. Pools with 2¼" Diameter Threaded Hoses

1. Attach the adapter for either Intex or Bestway to the central hose connector

under the base. Make sure the o-ring is in the collared tube adapter prior

to attachment (see figure 4).

2. Screw existing pool return hose onto the adapter. Be sure to place the thick

connector gasket between the hose and the adapter for a tight seal.

CONTINUE ON TO 3

3) Solar Heater Placement

Extend the two legs on the underside of the heater and face the heater in the direction of

the sun's natural path.

4) Solar Heater System

The basic solar heater assembly should resemble the set in figure 5.

NOTE: If solar heater needs to be further from the filter than the hoses allow, you

may need to purchase a longer hose with the 1½" diameter openings. A 1½"-1½"

coupler is needed to allow you to connect an additional hose if necessary (not

included). In this case make certain you have two hose clamps to secure the hoses

to the coupler. If the hoses are too wide to fit the hose connector, put the 1¼"-1½"

tube reducer on the hose connector and continue.

CAUTION :ENSURE ALL HOSE CONNECTIONS ARE TIGHT AND THE HOSES ARE

NOT KINKED OR BENT AT SEVERE ANGLES. IF THE HOSES ARE LEAKING, CHECK

TO MAKE SURE ALL OF THE PARTS THAT HAVE O-RINGS HAVE THEM ATTACHED

AND ARE SCREWED ON TIGHTLY. DO NOT OVER TIGHTEN HOSE CLAMPS (35 IN/

LB MAX TORQUE)

NOTE: The short hose is only used to connect multiple solar heaters together.

INITIAL OPERATION

Once the solar heater has been assembled and the hoses are connected to the filter

pump and pool return, unblock the flow of water into the pool return hose and turn on

the pump and filter system. Bubbles will shoot out of the return nozzle into the pool initially while air is pushed out of the solar heater.

If this persists for longer than 2 or 3 minutes, check for and repair any leaks in the hoses

or connections.

FOR BEST RESULTS: To reduce heat loss, use a pool cover on your pool overnight, run your filter system during daylight hours

and cover the solar heater at night (if running the system).

Hose to Pool

Reducer

(if needed)

Pool Return

Hose

Outlet

Hose Clamp

Connector

Figure 3

40mm Hose

Flat Gasket

to Pool

0-ring

Adapter for Intex Pools

Shown (use Adapter for

Outlet Connector

Bestway if needed)

Figure 4

Outlet Connector

Figure 5

SAVE THESE INSTRUCTIONS

Inlet Connector

Hose from

Filter/Pump