Gree NEO24HP230V1A Руководство пользователя - Страница 8
Просмотреть онлайн или скачать pdf Руководство пользователя для Тепловой насос Gree NEO24HP230V1A. Gree NEO24HP230V1A 12 страниц. High-wall ductless air conditioning & heating system
Также для Gree NEO24HP230V1A: Краткое руководство по эксплуатации (2 страниц)
Печатать страницу
TWD-0813-033 Neo Manual REV:Layout 1 9/27/13 11:15 AM Page 15
OPERATION OF WIRELESS REMOTE CONTROLLER
VERTICAL SWING LOUVERS
• Press the Vertical Swing Louver button to select five
different vertical (up & down) air discharge directions
including Continuous Sweep.The Vertical Swing Louver
icon will be displayed. Press this button to set
swing angle, which circularly changes as below:
0
1
2
OFF
8
7
Indicates louver swings back and forth in the five
places, as shown in the figure.
X-FAN MODE
When operating in humid areas, neo has a DRY COIL function
called X-Fan that will allow the indoor fan to run for a pre-determined
amount of time after the unit is turned off (cooling or dry modes)
to ensure that additional moisture is removed from coil. Push the
"X-FAN" button to enable this feature. The X-FAN
be displayed on remote controller. To deactivate this feature, push
the "X-FAN" button again.
TURBO MODE
The desired setpoint, either in heating or cooling, can be achieved
faster if TURBO mode is used. After selecting the "HEAT" or
"COOL" mode button, push the "TURBO" button. The TURBO
icon will be displayed on the remote controller and the unit
will run at ultra high speed fan. To deactivate the feature, push the
"TURBO" button again. The unit will return to normal operation.
3
4
Swing Louver Display
6
5
icon will
X-Fan Mode Display
Turbo Mode Display
OPERATION OF WIRELESS REMOTE CONTROLLER
SLEEP MODE
The neo will automatically adjust room temperature during
your sleep time. This slight change in temperature will not affect
your comfort level due to the natural effects that sleeping has on
the body, but it will save on energy consumption and will lower
your electric bill. Press the SLEEP button to select Sleep Mode.
The SLEEP icon will appear.
In Cool or Dry modes:
The unit will run at current room setpoint for 1 hour.
After 1 hour, the setpoint will increase by 2° F.
After 2 hours, the setpoint will increase by 4° F and
maintain this setpoint until Sleep Mode is cancelled.
In Heat mode:
The unit will run at current room setpoint for 1 hour.
After 1 hour, the setpoint will decrease by 2° F.
After 2 hours, the setpoint will decrease by 4° F and
maintain this setpoint until Sleep Mode is cancelled.
13
Sleep Mode Display
14