Game Winner PL200GW Руководство по эксплуатации - Страница 14

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Лестницы Game Winner PL200GW. Game Winner PL200GW 20 страниц. 15’ ladder stand

STEP 7

Attach the stabilizer bar extension tube (7) to the

middle ladder section (2) through the mounting

bracket with one 1/4-20 X 1-1/2 IN bolts (20) and

one 1/4-20 nut (24). SEE FIGURE 7.

Slide the stabilizer bar (9) into the extension tube

(7) and attach the two pieces together using one

1/4-20 X 1-1/2 IN bolt (20) and one wing nut (19).

The bolt must go through both the extension tube

(7) and stabilizer bar (9) at appropriate hole to

achieve desired distance from tree. Adjustment in

length may be needed when ladder is uprighted

later in Installation and Use Instructions. SEE

FIGURE 7.

NOTE: Treestand should ALWAYS be fully

assembled on the ground prior to mounting it in

the tree.

STEP 8

Pre-assemble the 16' criss-cross straps (16) and 6'

ratchet strap (14) as follows:

a. Attach the two long ends of the 16' criss-cross

straps (16) to each side of the rear frame tube

on each side of the seat platform tree blade (11).

These long stabilizer straps should be attached by

pulling the free end of the strap through the loop

end of the strap to create a cinch knot around the

frame tube. SEE FIGURES 8A AND 8B.

b. To aid in the ease of installation, pre-attach each

end of the 6' ratchet strap (14) to each side of the

rear frame tube, just inside of the 16' criss-cross

strap (16) on both sides of the seat platform tree

blade (11). Use the same method as listed in step

a. This way each end of the main ratchet strap is

pre-attached before the stand is lifted from the

ground. SEE FIGURE 8B showing all four ends

attached.

FIGURE 7

FIGURE

Instruction Manual : 15' LADDER STAND