Game Winner PL200GW Руководство по эксплуатации - Страница 18

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Лестницы Game Winner PL200GW. Game Winner PL200GW 20 страниц. 15’ ladder stand

STEP 4

7. Standing on ladder step, lean toward tree with

previously installed 6' ratchet strap (14) now in hand.

a. Wrap the previously installed end of the long strap

around the tree and feed through the slot in the

ratchet mechanism. SEE FIGURE 12A.

NOTE: Be sure to feed the long strap correctly so

there are no twists in the strap.

b. Pull tail of long strap until most of the slack is taken

out. Be sure entire strap is even and at the same

level all around tree. SEE FIGURE 12B.

c. Use the ratchet to tighten the strap to tree. The

tightened strap will stabilize the stand to tree and

prevent movement. SEE FIGURE 12C.

NOTE: Make sure there is at least two full

revolutions of strap on the ratchet spool before

the strap tightens. Proper tension will ensure

the stand is secured to the tree. Do not allow

excessive strap to build up in the ratchet as this

will prevent the ratchet teeth from engaging and

can cause slippage.

To release ratchet, simply pull the release lever

and open tightening lever wide open (flat). SEE

FIGURE 12D.

8. If necessary, re-check and adjust the 6' ratchet straps

(14), 16' criss cross straps (16) and horizontal stabilizer

bar assembly to securely attach the treestand to the

tree. The tree blades must be touching the tree.

SEE FIGURE 13.

9. You are now ready to use your ladder stand!

IMPORTANT

Reverse the Set-Up and Use Instructions to

take the ladder stand down.

FIGURE

12A

FIGURE

12B

FIGURE

12C

FIGURE

12D

FIGURE 13

Instruction Manual : 15' LADDER STAND

Ratchet strap

Criss cross

Strap