Maiwe MIEN2018 Руководство пользователя - Страница 13

Просмотреть онлайн или скачать pdf Руководство пользователя для Переключатель Maiwe MIEN2018. Maiwe MIEN2018 18 страниц. Rack mount industrial ethernet switch

Печатать страницу

MIEN2016/2018/2024/2026 Rack Mount Industrial Ethernet Switch

Before laying the cable, check whether the cable is damaged, whether

there are factory records and quality assurance certificates that prove its

quality

The specifications, quantity, routing direction, and location of the cables

to be laid should meet the design requirements of the construction drawing,

and the wiring length of each cable should be determined according to the

actual location

User cables and power cords are laid separately

There must be no broken wires or joints in the middle of the laid cables

The cables should be laid out neatly in the aisle, and the bends should

be even, smooth and straight

The cable should be straight in the channel, and should not go out of the

channel and block other cable entry and exit holes. The cable should be tied

and fixed at the location of the cable exit from the channel or the cable bend.

When the cables, power cords, and ground wires are laid in the same

slot, the cables, power cords and ground wires cannot be overlapped or mixed.

When the cable is too long, the cable must be neatly placed in the middle of the

cable rack, and cannot be pressed on other cables

When laying pigtails, prevent the optical cable from knotting and

minimize the turning points, and the turning radius should not be too small. The

lashing should be moderately tight and not too tight. When laying on the cable

rack, it should be placed separately from other cables

Both ends of the cable should have corresponding marks, and the

content of the marks is concise and easy to maintain

Note:

When laying pigtails, prevent the optical cable from kinking and

minimize the turning point, and the turning radius should not be too small. If

the turning radius is too small, it will cause serious loss of the link optical

signal. Affect the quality of communication.

2.3. Simple test

2.3.1. System self-check

All the service port indicators on the front panel will flash once when the

device is powered on, indicating that the port is working normally. After that, the

corresponding Power will always be on, and the Run light (system running

status indicator) will flash at intervals of 1s.

- 9 -