AIRFER DIAMOND EVO +AERO 1000 Руководство пользователя - Страница 3

Просмотреть онлайн или скачать pdf Руководство пользователя для Велосипед AIRFER DIAMOND EVO +AERO 1000. AIRFER DIAMOND EVO +AERO 1000 6 страниц.

happen during starting and the engine gets suddenly accelerated, to avoid the paratrike going

forwards causing any accident.

BESIDES, EVERY TIME YOU GO TO FLY, FIRSTLY YOU HAVE TO:

➢ warm the engine before flying for about 5 minutes accelerating the engine little by little and

increasing rpm gradually.

➢ your first flight with the paratrike cannot last more than 30 minutes

➢ check all the engine and paratrike parts and fitting, screws, propeller, exhaust, etc.

AND AFTER FLYING YOU HAVE TO:

➢ disconnect battery from yellow buttom (do NOT pull from the cables but take from the

yellow plastic connector).

START THE AERO 1000 ENGINE

1. CONNECT THE BATTERY. As you can see the battery is disconnected to avoid any problem,

or even for it to be discharged. We recommend you to disconnect always the battery when

you finish to fly and are keeping the unit stopped for some time, and also for transporting

the paratrike

2. MAKE ALWAYS SURE that you have enough FUEL in the fuel tank, because in case you ran

out of fuel and you tried to start the engine the fuel pump may be seriously

REMEMBER this is a 4 stroke engine and you do NOT have to use oil with the

3. You can see a toggle switch near the engine, POSITION the TOOGLE SWITCH in ON position.

When you do it you are hearing an small noise in the fuel pump, you have to wait till this

noise stops (it may takes about 4 seconds, it is important to wait till the noise stops, than

means that fuel pump is completely filled), do NOT try to start the engine till the fuel pump

is filled

4. PRESS the lower buttom in the hand throttle, keep this buttom pressed till the engine starts,

you can press during 6-7 seconds, in case the engine does not start then stop pressing the

buttom for 2-3 seconds and press it again till the engine starts.

5. When the engine starts you have to wait for some seconds till the engine become to get

warm, so you can begin to accelerate little by little for the engine gets warm gradual and

completely (this can take about 2 or 3 minutes, depending on the weather condition). Now

the engine is ready to be flown.

6. To STOP the engine you have to push the buttom located in the upper part of hand throttle.

Keep pushing this buttom during few seconds till the engine stops. You will use this buttom

to stop the engine when you finish your flight, but you can also use the toggle switch putting

it in OFF position in case you are on the ground near to the engine.

✓ REMEMBER always to put the toggle switch in OFF position when you finish the flight and you are

transporting or storing the paratrike. Otherwise the battery may be discharged, also for safety.

damaged.............

fuel....................