Adexa ZH-RS80 Руководство по эксплуатации - Страница 5

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Плиты Adexa ZH-RS80. Adexa ZH-RS80 6 страниц. Gas tilting braising pan

Instruction Manual

pressure regulators. (This machine is only suitable for low pressure regulating valves)

3.2 gas connection

※ A quick shut-off air supply valve must be installed before installing the machine, and it must

be placed in an upstream position near the machine that is easily accessible.

* Make sure that the machine is the same type as the gas that is connected. If it is different, do not

turn it on, and the gas connection pipe is painted yellow.

* Pipes connected to the machine must be connected with suitable metal pipes.

※ The machine should be tested with liquefied petroleum gas.

※ If the pipeline pressure is 10% higher than the rated pressure required by the machine, an

adjuster must be installed to ensure the rated pressure is reached.

※After connecting, use soapy water test or test the test pipe connection for leaks, "Do not use fire

source ignition test!"

3.3 Notes

※Do not place flammable items (such as towels) on any position on the stove surface, otherwise it

may cause a fire accident.

※ Close the gas valve immediately after use.

※If you find a leak, you should immediately close the gas valve, open the window to enhance

ventilation, and do not switch the power supply and electricity to be repaired before use.

3.4 maintenance

※ Always clean the dirt and oil basin on the pit board. (Recommended: twice a day)

※ If it is not used for a long time, first clean the surface of the stainless steel with a cloth coated

with gasoline and put it in a well ventilated place.

※When cleaning the equipment, do not use tools such as detergents, brushes or scrapers

containing abrasive substances to clean the stainless steel surface, as residual iron filings can cause

rust. Also, wipe in a satin direction. Do not use a product containing chlorine (bleach, hydrochloric

acid, etc.) to clean the steel surface, even if these products have been diluted.

※ This product cannot be washed directly with water.

※Do not use corrosive substances (such as potassium chloride) to clean the floor under the

equipment.

※ Regularly clean the burner and the dirt on the volcanic stone. (recommended once a week)

4、Instructions for use:

※ Turn the knob counterclockwise from the closed state to the "★" position, press the knob to

the bottom, and press the electronic firearm continuously to ignite the small fire burner (fire). Press

the knob down for 20 seconds; and observe the small fire burner (fire) on the see-through port.

When the knob is released, the small fire burner (fire) is determined to be ignited; if not, repeat the

above operation until it is ignited. If the stove is deactivated for a long time or used for the first

time, it may be a little longer (about two to three minutes), which is normal.

※When the small fire burner (fire type) is ignited, turn the knob counterclockwise to the

maximum flame position, and "00" is the maximum flame to ignite the main burner. (To set the