CentralPneumatic 62381 Руководство пользователя - Страница 10
Просмотреть онлайн или скачать pdf Руководство пользователя для Краскопульт CentralPneumatic 62381. CentralPneumatic 62381 20 страниц. Hvlp gravity feed
Печатать страницуDelayed or inadequate cleaning will permanently clog the Spray Gun.
Latex paint hardens quickly and permanently inside Spray Gun.
Before First Use
NOTICE: Before first use, clean the
Spray Gun thoroughly.
If not removed, the material used for testing and
corrosion prevention will contaminate paint.
1. Remove Nozzle by hand.
2. Depress Trigger to retract Fluid Needle, then
remove Fluid Tip with spray gun wrench
(sold separately). Release Trigger.
Note: Do not bend Fluid Needle.
3. Remove Fluid Knob by hand, then remove
Fluid Spring and Fluid Needle.
Nozzle
Fluid
Tip
Fluid
Inlet
Trigger
Figure D
Note: Do not immerse Spray Gun Body in liquid.
Do not allow liquid to enter the air inlet.
4. Place parts, other than Spray Gun Body, into
container with warm soapy water. Allow to soak,
then scrub parts, using brushes and toothpicks
from spray gun cleaning kit (sold separately).
Fluid Tip Selection
The choice of Fluid Tip Set will vary according to the consistency of the fluid being sprayed. Consult paint
manufacturer recommended spray tips and use Table A to select a Tip Set appropriate to the job.
Moves Like
Consistency
Water, Alcohol
Sugar Water,
Simple Syrup
Room Temperature
Pancake Syrup
Latex Paint
Glue
Note: Chart provided for reference only. Additional fluid tips sizes not included.
Page 10
NOTICE
Clean the Spray Gun IMMEDIATELY after EVERY use.
Fluid
Needle
Fluid
Fluid
Spring
Knob
Table A: Fluid Tip Set Suggestions
Very Light
Stains, Dyes, Thin Automotive Base
Automotive Lacquers, Thin Woodworking,
Light
Clear Coats with a VOC of 3.5 or Higher
Wood Standard Lacquers and Enamels,
Medium
Clear Coats with a VOC of 2.1 or Lower,
Primer Sealing Coats and Urethane
Heavy
Latex Paint, High Build Primer
Very Heavy
Gel Coat, Industrial Glue
For technical questions, please call 1-888-866-5797.
Note: To prevent damage to the passages, do not
use metal objects to clean the Nozzle and Fluid Tip.
5. Clean inside of Spray Gun by pouring warm soapy
water into the Fluid Inlet, then run a flexible round
brush (sold separately) through the passage
between the Fluid Inlet and Nozzle opening.
6. Wipe down Spray Gun Body with a
clean cloth and warm soapy water.
7. Rinse Cup, along with any tubes or
filters, in warm soapy water.
8. Make sure all parts are free from grease
and oil. Repeat cleaning if necessary.
9. Rinse all parts and inside of Spray Gun,
except Air Inlet, with warm water.
10. Thoroughly blow dry all parts and inside
of Spray Gun with compressed air.
11. Reassemble Spray Gun, making sure to retract
Fluid Needle when replacing Fluid Tip.
Examples
Figure E
Suggested Tip Sets in mm
1.0-1.2
1.2-1.4
1.5-1.8
1.8-2.5
2.0-3.6
Item 62381