Bristan Blitz BTZ BAS C Инструкции по установке и руководство пользователя - Страница 8
Просмотреть онлайн или скачать pdf Инструкции по установке и руководство пользователя для Сантехническая продукция Bristan Blitz BTZ BAS C. Bristan Blitz BTZ BAS C 20 страниц.
Печатать страницу
Installation cont.
Basin Mixer
1. Identify all components are present prior to starting installation using the diagram
overleaf.
2. Fit the mixer body (8) to the basin ensuring the plinth (9) and washer (10) are fitted
between the basin and the mixer body (8).
3. Make Sure that the threaded insert (11) is screwed fully into the mixer body (8)
4. Fit the rubber washer (12) and the 'C' shaped metal washer (13) to the underside of the
basin; and screw the brass 'C' shaped fixing (14) with the 2 small screws fitted on to the
bottom of the threaded insert (11) as tight as possible by hand.
5. Tighten the 2 small screws on the brass 'C' shaped fixing (14) using a suitable
screwdriver to secure the basin mixer into place, on the basin.
6. Screw in the flexible connecting pipes (17) to the mixer (DO NOT OVERTIGHTEN) and
connect the hot and cold water supplies.
7. Fit the clicker waste (15) to the basin ensuring a rubber washer is fitted between the
basin and the waste. Use a pure silicon sealant where necessary. Place the other rubber
washer under the basin and secure in place by tightening the backnut. In order to fill the
basin, the button in the middle of the waste needs to be pressed down. To release the
water, press the button again.
8. Lift the handle up and turn in both directions, letting the water flow for a few minutes to
check all joints and connections for any leaks.
1.
Handle
2.
Handle Lever
3.
Cap
4.
Grub Screw
5.
Shroud
6.
Cartridge Retaining Nut
7.
Cartridge
8.
Mixer Body
9.
Plinth
08
x1
10.
Rubber Washer
x1
11.
Threaded Insert
x1
12.
Rubber Washer
x1
13.
'C' Shaped Metal Washer
x1
14.
'C' Shaped Metal Fixing
x1
15.
Clicker Waste
x1
16.
Flow Straightener
x1
17.
Flexible Connecting Pipes
x1
x1
x1
x1
x1
x1
x1
x1
x2