Aguilar Tone Hammer Preamp/DI Руководство пользователя - Страница 2
Просмотреть онлайн или скачать pdf Руководство пользователя для Усилитель Aguilar Tone Hammer Preamp/DI. Aguilar Tone Hammer Preamp/DI 4 страницы. Preamp/direct box
Печатать страницу
1. Top Panel Controls and Functions
GAIN: Controls input sensitivity level
TREBLE: +/- 18 dB @ 4 kHz
BASS: +/- 18 dB @ 40 Hz
MID FREQ: 180 Hz to 1 kHz
MID: +/- 17 dB of cut or boost
MASTER: Controls output level
ENGAGE footswitch: toggles between on/bypass (blue LED indicates on)
AGS footswitch: toggles AGS on/off (orange LED indicates on)
2. Side Panel Controls and Functions
IN: ¼" instrument input
DC IN: Input for external power supply
PRE/POST: This will place the DI signal either pre or post EQ.
• Pre: Your signal goes to the DI XLR output before your GAIN, AGS and EQ
settings. Leave the switch out for this function.
• Post: GAIN, AGS, EQ and MASTER settings will be sent to the DI XLR output jack.
Push the switch in for this function.
DI: Balanced XLR output
GND/LIFT: If there is a hum when using the DI, there may be a ground loop. In many
cases, pushing in the GND/LIFT button can fix this problem.
OUT: ¼" instrument output
3. Specifications
Input impedance: 1meg Ohm
¼" output level: 4VRMS maximum
XLR output level: 8VRMS maximum balanced
¼" output noise: -95dBu 'A' weighted
XLR output noise: -98dBu 'A' weighted
Current consumption: 7mA
Power Requirements: Two 9-volt batteries, phantom power or an external DC power
supply: 18-20V 0.3A, 2.1mm plug, center terminal polarity is negative. We recommend
the Aguilar PSU2 for best results.
4. Basic Setup
1. Plug in your instrument, the TONE HAMMER, and your amplifier. With MASTER
volume down, bring the GAIN control to 12 o'clock.
2. Turn on your amplifier and engage the TONE HAMMER.
2