Bristan K 1/2 C Инструкции по установке и руководство пользователя - Страница 18

Просмотреть онлайн или скачать pdf Инструкции по установке и руководство пользователя для Сантехническая продукция Bristan K 1/2 C. Bristan K 1/2 C 20 страниц.
Также для Bristan K 1/2 C: Инструкции по установке и руководство пользователя (5 страниц)

Печатать страницу

Troubleshooting

Symptom

No flow or poor flow

rate.

Water dripping for a few

seconds after the tap

has been turned off.

Constant dripping /

leaking when the tap is

not in use.

Fitting does not turn on.

Water does not come

out of the showerhead

when using the bath

shower mixer.

Cause

Partially closed stop or service

valve in water supply pipework to

the tap.

Head of water is below the

minimum distance required.

Possible airlock / blockage in

supply pipework

Valve not opening fully.

This is caused by 'capillary

action' and residual water in the

spout being siphoned out. This

should only last for a couple of

seconds.

Valve not fully shutting off.

Water supplies not turned on.

Closed stop or service valve.

Diverter mechanism not fully

open.

Insufficient water pressure /

header height.

Remedy

Open stop or service valve.

Refer to the Specification section

for minimum pressures required.

Remove water supplies from the

fitting and flush the system to

remove any airlocks / debris.

Service fitting. Refer to

maintenance section on page 15-

16.

Service fitting and replace

cartridge / valve. Refer to

maintenance section on page 15-

16.

Check that the water supplies to

the fitting are turned on.

Open stop or service valve.

Open the diverter mechanism

fully by turning the diverter lever.

Refer to the specification section

for minimum pressures required.