Bristan Opac TS1503 Инструкции по установке и руководство пользователя - Страница 3

Просмотреть онлайн или скачать pdf Инструкции по установке и руководство пользователя для Блок управления Bristan Opac TS1503. Bristan Opac TS1503 20 страниц. Thermostatic shower valves

Печатать страницу

Important Safety Information

Please make sure you read these instructions and retain for future use.

All products manufactured by Bristan are safe, providing they are installed and used

correctly and also receive maintenance when needed.

These fittings, including the connecting water and waste system need to be installed

in accordance with and meet the requirements of the Water Supply Regulations 1999

(Water Fittings) and current by-laws. If you are in doubt about your ability to install

this product correctly or safely, you should employ the services of an experienced

qualified plumber.

This product must not be modified in any way otherwise this will invalidate the

guarantee. Remove all packaging and check the contents for damage before starting

installation.

Warning:

Before installing the new mixer valve it is essential that you thoroughly

flush through the pipework in order to remove any remaining swarf,

solder, etc. Failure to carry out this procedure could cause problems or

damage to the workings of the mixer tap.

Fitting isolating valves to the inlet feeds is required for ease of maintenance.

Warning:

Do not operate the mixer if you suspect it is frozen. Do not site the mixer

valve where it might be subjected to freezing conditions.

Consider the following whilst using power tools:

•

Prior to drilling into walls, check there are no hidden electrical cables or

wires and there are also no water pipes. These can potentially be found

using an electrical or metal detector. You may also need to know some

of the schematics of previous installations to determine the suitability

and accommodation of the installation.

•

Wear the correct PPE, especially ear, eye and hand protection

when using power tools. Unplug any mains equipment after use.

•

Keep electrical equipment away from sources of water.

•

If a blow-lamp is used when plumbing, the flame must be kept well away from

the product otherwise damage may occur.

If in doubt, contact a registered plumber, your Local Water Authority or the

Secretary of The Institute of Plumbing, address as follows;-

The Institute of Plumbing,

64 Station Lane,

Hornchurch,

Essex, RM12 6NB

Tel:01708 472791

Need help? Give us a call on 0330 026 6273 and speak to one of our trained advisors.