Gamma 5003 Руководство пользователя - Страница 16

Просмотреть онлайн или скачать pdf Руководство пользователя для Машины для изготовления струн Gamma 5003. Gamma 5003 20 страниц. 6 point mounting
Также для Gamma 5003: Руководство пользователя (19 страниц), Руководство пользователя (20 страниц), Руководство пользователя (20 страниц)

MAINTENANCE & ADJUSTMENT

direction. If the clamp leaves impressions or damages the string, it may be excessively tight

and should be adjusted by turning the Adjustment Knob counter clockwise to open the gap

between the jaws. The clamp jaws should be cleaned periodically to be free from dirt, oil, and

any string coating residue to grip properly. Knife sharpening stones are excellent for removing

build-up on the diamond coated surfaces and are available.

Adjusting the String Clamp Jaw

Spacing

The string clamps will need minor adjust-

ments according to what string type, con-

struction, and gauge you are using.

To adjust the gap (clamping pressure)

between the clamp jaws, insert the string

through the racquet as if you were beginning

the main strings. Clamp the strings and pull

tension. If the string slips through the jaws of

Adjustment

the clamp, tighten the clamp by squeezing

Knob

the clamp jaws together by hand while turn-

ing the Adjustment Knob, in the clockwise

Adjusting the Clamp Base Locking

Nut

In the event the Locking Lever rotation is

insufficient to ensure smooth operation of the

clamp base, very minor adjustments to the

Clamp Base Locking Nut can be made with

the supplied 17mm socket wrench. Tighten

or loosen the locking nut in very small incre-

ments to provide more clamping pressure or

running clearance as needed.

Quick Action Clamp Base Removal

Quick Action clamp bases can be removed

from the turntable for maintenance or clean-

ing by removing clamp stop located at the

end of the slot in the turntable. To remove the

clamp stop, remove the two screws holding

the clamp stop in place from the underside of

the turntable. Lift the clamp stop out of the

slot, slide the clamp base to the end of the

slot and lift it out. Replace the clamp base

and clamp stop in reverse order.